Abstract:A three-dimensional multi-cell model based on a prototypical, planar solid oxide fuel cell (pSOFC) stack design using compliant mica-based seal gaskets was constructed in this study to perform comprehensive thermal stress analyses by using a commercial finite element analysis (FEA) code. Effects of the applied assembly load on the thermal stress distribution in the given integrated pSOFC stack with such a compressive sealing design were characterized. A comparison was made with a previous study for a similar comprehensive multi-cell pSOFC stack model but using only a rigid type of glass–ceramic sealant instead. Simulation results indicate that stress distributions in the components such as positive electrode-electrolyte-negative electrode (PEN) plate, PEN-supporting window frame, nickel mesh, and interconnect were mainly governed by the thermal expansion mismatch rather than by the applied compressive load. An applied compressive load of 0.6MPa could eliminate the bending deformation in the PEN-frame assembly plate leading to a well joined structure. For a greater applied load, the critical stresses in the glass–ceramic and mica sealants were increased to a potential failure level. In this regard, a 0.6MPa compressive load was considered an optimal assembly load. Changing the seal between the connecting metallic PEN-supporting frame and interconnect from a rigid type of glass–ceramic sealant to a compressive type of mica gasket would significantly influence the thermal stress distribution in the PEN plate. The critical stress in the PEN was favorably decreased at room temperature but considerably increased at operating temperature due to such a change in sealing design. Such differences in the stress distribution could be ascribed to the differences in the constrained conditions at the interfaces of adjacent components under various sealing designs.

Simulation and Analysis of Thermal Stress and Sintering Warpage of Planar Solid Oxide Fuel Cells

Simulation and Analysis of Sintering Warping and Thermal Stress for a Cermet Half-Cell of Solid Oxide Fuel Cells

Solid Oxide Electrolysis Cell under Real Fluctuating Power Supply with a Focus on Thermal Stress Analysis

Modeling of Solid Oxide Fuel Cell Sintering Stress and Deformation

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Towards Feasible Temperature Management and Thermo-Mechanical Stability of Carbon-Assisted Solid Oxide Electrolysis Cell

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

Real-time deformation and stress response of the planar SOFC during sintering

Modeling of cooperative defect transport and thermal mismatch in a planar solid oxide fuel cell

A Numerical Investigation of the Thermal Stresses of a Planar Solid Oxide Fuel Cell

Influence of Interface Morphology on the Thermal Stress Distribution of SOFC under Inhomogeneous Temperature Field

Sensitivity analysis of thermal stress in a cathode porous electrode for a planar solid oxide fuel cell

Thermal Stress in Full-Size Solid Oxide Fuel Cell Stacks by Multi-Physics Modeling

Numerical simulation and analysis of the thermal stresses of a planar solid oxide electrolysis cell

Coarse-grained molecular dynamics modeling and parameter analysis for sintered interface structures in sandwiched tri-layers reversible solid oxide fuel cell

Modeling and prediction of structural/thermophysical properties of sintered NiO/YSZ anode for SOFC by molecular dynamics method

Numerical research on carbon activity, fuel utilization, chemical reaction, and temperature distribution for IT single planar SOFC

Thermal stress analysis of planar solid oxide fuel cell stacks: Effects of sealing design

Characteristic simulation with various anode support thicknesses of membrane electrode assembly in SOFC