Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Influence of Interface Morphology on the Thermal Stress Distribution of SOFC under Inhomogeneous Temperature Field

Solid Oxide Electrolysis Cell under Real Fluctuating Power Supply with a Focus on Thermal Stress Analysis

Simulation and Analysis of Thermal Stress and Sintering Warpage of Planar Solid Oxide Fuel Cells

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Performance Analysis of Flat-chip Solid Oxide Fuel Cells with Discrete Interconnector Designs

A Numerical Investigation of the Thermal Stresses of a Planar Solid Oxide Fuel Cell

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

Three-dimensional numerical investigation on the effect of interconnect design on the performance of internal reforming planar solid oxide fuel cell

Numerical simulation and thermal stress analysis of direct internal reforming SOFCs

Effect of Interconnector Rib on Optimization of SOFC Structural Parameters

Modeling of cooperative defect transport and thermal mismatch in a planar solid oxide fuel cell

Thermal Stress in Full-Size Solid Oxide Fuel Cell Stacks by Multi-Physics Modeling

Experimental investigation of temperature distribution in solid oxide fuel cells

Sensitivity analysis of thermal stress in a cathode porous electrode for a planar solid oxide fuel cell

Thermal Shock Resistance and Failure Probability Analysis on Solid Oxide Electrolyte Direct Flame Fuel Cells

Effects of a cooling channel on the creep damage and failure probability of planar solid oxide fuel cells

Coupled Electrochemical-Thermo-Stress Analysis for Methanol-Fueled Solid Oxide Fuel Cells

Thermal Stress Analysis of a Solid Oxide Fuel Cell Considering Interconnect Deformation

Real-time deformation and stress response of the planar SOFC during sintering

A novel flow field design with flow re-distribution for advanced thermal management in Solid oxide fuel cell

Modeling of Solid Oxide Fuel Cell Sintering Stress and Deformation