Abstract:To elucidate the thermofluid reacting environment and thermal stress inside a solid oxide fuel cell (SOFC), a three-dimensional SOFC model is implemented by using the finite element method in the commercial software COMSOL Multiphysics®, which contains both a geometric model of the full-cell structure and a mathematical model. The mathematical model describes heat and mass transfer, electrochemical reactions, internal reforming reactions, and mechanical behaviors that occur within the cell. A parameter study is performed focusing on the inlet fuel composition, where humidified hydrogen and methane syngas (the steam-to-carbon ratio is 3) as well as the local distribution of temperature, velocity, gas concentrations, and thermal stress are predicted and presented. The simulated results show that the fuel inlet composition has a significant effect on the temperature and gas concentration distributions. The high-temperature zone of the hydrogen-fueled SOFC is located at the central part of units 5, 6, and 7, and the maximum value is about 44 K higher than that of methane syngas-fueled SOFC. The methane-reforming and electrochemical reactions in the anode active layer result in a significant concentration gradient between the anode support layer and the active layer of the methane syngas-fueled SOFC. It is also found that the thermal stress distributions of different fuel inlet compositions are rather different. The maximum stress variation gradient between electrode layers of hydrogen SOFC is larger (44.2 MPa) than that of methanol syngas SOFC (14.1 MPa), but the remaining components have a more uniform stress distribution. In addition, the electrode layer of each fuel SOFC produces a significant stress gradient in the y-axis direction, and stress extremes appear in the corner regions where adjacent assembly components are in contact.

Optimization of interconnect flow channels width in a planar solid oxide fuel cell

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Performance Analysis of Flat-chip Solid Oxide Fuel Cells with Discrete Interconnector Designs

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

Optimized design of planar solid oxide fuel cell interconnectors

Effect of Interconnector Rib on Optimization of SOFC Structural Parameters

Three-dimensional numerical investigation on the effect of interconnect design on the performance of internal reforming planar solid oxide fuel cell

Numerical Simulation of Multi-Channel Planar Solid Oxide Fuel Cell Unit by Integrating Continuum Micro-Scale Pen Sub-Model

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Numerical Study on Effects of Flow Channel Length on Solid Oxide Fuel Cell-Integrated System Performances

Numerical Investigation on Impacts on Fuel Velocity Distribution Nonuniformity among Solid Oxide Fuel Cell Unit Channels

A numerical study of the performance of solid oxide fuel cell with bi-layer interconnector

Effect of the Reactant Transportation on Performance of a Planar Solid Oxide Fuel Cell

Simulation and Analysis of Thermal Stress and Sintering Warpage of Planar Solid Oxide Fuel Cells

Effect Of Bi-Layer Interconnector Design On The Current Density Of Solid Oxide Fuel Cells

Discrete triangular interconnector design for performance enhancement of planar solid oxide fuel cells

Effects of Radial and Circumferential Flows on Power Density Improvements of Tubular Solid Oxide Fuel Cells

Numerical Analysis of Thermal Stress for a Stack of Planar Solid Oxide Fuel Cells

Modeling Analysis of SOFC Supported on Anode Employing Straight Channel Fabricated by Phase-Inversion Method

Comparison and optimization of electrochemical and thermal performances of SOFC with different configurations of a metal foam flow field

Effect of Bi-Layer Interconnector Design on Mass Transfer Performance in Porous Anode of Solid Oxide Fuel Cells