Abstract:Low power density and large temperature gradient are the key factors restricting the wider adoption of solid oxide fuel cell stacks in powering vehicles. Placing inserts in the flow channels to control electrochemical reaction and heat generation could improve power density or reduce temperature gradient. In this study, we constructed a 2-D axisymmetric model to investigate the influence of the geometric parameters and operating conditions of a tubular SOFC with inserts on its electrical and thermal performance. The average mass transfer coefficient is proposed for quantitative analysis. An increase in average mass transfer coefficients indicates stronger diffusive mass transfer in porous electrode and convective mass transfer in flow channels, which could in general lead to higher cell output powers and larger local temperature gradients. We show that the cell performance is more sensitive to the parameters of the anode side than that of the cathode side due to the existence of the inserts in fuel channel. The cathode thickness and porosity barely affect the average mass transfer coefficient. We demonstrate that fuel inlet velocity is the primary factor affecting the cell output power while the anode thickness significantly affects the maximum cell temperature gradient. As the fuel inlet velocity varies from 1.0 m⋅s −1 to 4.0 m⋅s −1 , the output power could be increased by 50 %, and the maximum cell temperature gradient could be doubled as the anode thickness decreases from 1 mm to 0.25 mm. The influence of the cell geometric parameters on the cell output power is smaller than that of the fuel inlet flow rate. This study demonstrates the effectiveness of quantitative analysis based on average mass transfer coefficients. It helps improve our understanding of the heat and mass transfer performance in solid oxide fuel cells.

Effect of Bi-Layer Interconnector Design on Mass Transfer Performance in Porous Anode of Solid Oxide Fuel Cells

Effect Of Bi-Layer Interconnector Design On The Current Density Of Solid Oxide Fuel Cells

Performance Analysis of Flat-chip Solid Oxide Fuel Cells with Discrete Interconnector Designs

A numerical study of the performance of solid oxide fuel cell with bi-layer interconnector

Optimal Design of Bi-Layer Interconnector for Sofc Based on Cfd-Taguchi Method

Discrete triangular interconnector design for performance enhancement of planar solid oxide fuel cells

A novel interconnector design of SOFC

Effect of Interconnector Rib on Optimization of SOFC Structural Parameters

Performance enhancement of a beam and slot interconnector for anode-supported SOFC stack

Optimized design of planar solid oxide fuel cell interconnectors

Optimization of interconnect flow channels width in a planar solid oxide fuel cell

Effects of Radial and Circumferential Flows on Power Density Improvements of Tubular Solid Oxide Fuel Cells

Influence of Radial Flows on Power Density and Gas Stream Pressure Drop of Tubular Solid Oxide Fuel Cells

Effect of Radial Flows in Fuel Channels on Thermal Performance of Counterflow Tubular Solid Oxide Fuel Cells

Three-dimensional numerical investigation on the effect of interconnect design on the performance of internal reforming planar solid oxide fuel cell

Effect of the Reactant Transportation on Performance of a Planar Solid Oxide Fuel Cell

Design and Modelling of 3D Bionic Cathode Flow Field for Proton Exchange Membrane Fuel Cell

A study of mass transfer characteristics of secondary flows in a tubular solid oxide fuel cell for power density improvement

Significance of advanced porous configurations in enhancing solid oxide fuel cell performance: a comparative analysis between conventional porous anodes and state-of-the-art variants

Analyzing the thermal and electrical performance of a tubular SOFC with inserts by mass transfer coefficients

A comprehensive study on effective triple‐phase boundary density and its correlation with active anode thickness in solid oxide fuel cells