Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Numerical Study of a 20-Cell Tubular Segmented-in-series Solid Oxide Fuel Cell

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Numerical Investigation of Air Flow Characteristics for a Compact 5 × 10 Array Tubular Segmented-in-series Solid Oxide Fuel Cell Stack

Numerical Modeling and Current Collection Designs for Flat-Chip Solid Oxide Fuel Cell

Experimental Study on High-Efficiency Microtubular Solid Oxide Fuel Cell Stacks Using Various Fuels

Recent progresses in the development of tubular segmented-in-series solid oxide fuel cells: Experimental and numerical study

Numerical study of a bamboo-like micro-tubular solid oxide fuel cell

Numerical Simulation of Cell-to-cell Performance Variation Within a Syngas-Fuelled Planar Solid Oxide Fuel Cell Stack

Experimental investigation of temperature distribution in solid oxide fuel cells

Numerical Simulation of Tubular Solid Oxide Fuel Cells

Numerical Investigation of Heat/Flow Transfer and Thermal Stress in an Anode-Supported Planar SOFC

Numerical modeling of a novel hybrid system composed of tubiform solid oxide fuel cell and segmented annular thermoelectric generator (SOFC/SATEG)

A Reduced-Order Electrochemical Model for Analyzing Temperature Distributions in a Tubular Solid Oxide Fuel Cell Stack

Simulation and Analysis of Thermal Stress and Sintering Warpage of Planar Solid Oxide Fuel Cells

Numerical multi-physical optimization of operating condition and current collecting setup for large-area solid oxide fuel cells

A numerical study of the performance of solid oxide fuel cell with bi-layer interconnector

Numerical Investigation on Impacts on Fuel Velocity Distribution Nonuniformity among Solid Oxide Fuel Cell Unit Channels

Local heat transfer enhancement by recirculation flows for temperature gradient reduction in a tubular SOFC

Spatially resolved electrochemical performance and temperature distribution of a segmented solid oxide fuel cell under various hydrogen dilution ratios and electrical loadings

Highly Thermal Integrated Heat Pipe-Solid Oxide Fuel Cell

Analyzing the thermal and electrical performance of a tubular SOFC with inserts by mass transfer coefficients