Abstract:Solid oxide fuel cells (SOFCs) can directly convert the chemical energy in fuels and oxidants into electrical energy because of their high operating temperatures, making them efficient and environmentally friendly. The high-temperature operating characteristic gives SOFCs numerous advantages, including flexible fuel capability and high efficiency. However, it leads to a non-uniform temperature distribution that results in the performance degradation of SOFCs or even system failure. Owing to the high-temperature and gas-sealed operating environment, measuring the temperature distribution in SOFC stacks using experimental methods is extremely difficult. In this study, an SOFC internal temperature measurement device is developed and constructed to investigate the impacts of various factors, including the operating current density and gas flow rate, on the electrical output performance and temperature distribution within an SOFC stack. The experimental results indicate that the SOFC temperature gradually increases with increasing current density. Furthermore, the temperature difference between the spatial locations increases, and the inhomogeneity of the temperature distribution becomes more significant. During the growth of the current density i from 0.1 A/cm 2 to 0.5 A/cm 2 , the maximum temperature gradient on the SOFC electrodes reaches the lowest level at i = 0.3 A/cm 2 . The maximum current density and power density increase as the gas flow rate increases. However, the electrical efficiency and fuel utilization ratio gradually decrease, and the uniformity of the temperature distribution deteriorates. Air flux is the main factor that dominates the temperature distribution in SOFCs. The temperature on the cathode side is higher than that on the anode side. These results contribute to understanding the temperature distribution patterns in SOFCs and provide some guiding significance for SOFC design and operation optimization.

Direct Flame Fuel Cell Performance Using A Multi-Element Diffusion Flame Burner

Integration of Solid Oxide Fuel Cells with Multi-Element Diffusion Flame Burners

Experimental Characterization of a Direct Methane Flame Solid Oxide Fuel Cell Power Generation Unit

Numerical Simulation and Optimization of Operating and Structural Parameters for Solid Oxide Fuel Cell

Power and Heat Co-Generation by Micro-Tubular Flame Fuel Cell on a Porous Media Burner

Performance Characteristics of a Micro-tubular Solid Oxide Fuel Cell Operated with a Fuel-rich Methane Flame

Flat-chip Flame Fuel Cell Operated on a Catalytically Enhanced Porous Media Combustor

A Direct Flame Solid Oxide Fuel Cell for Potential Combined Heat and Power Generation

Direct Flame SOFCs with La[sub 0.75]sr[sub 0.25]cr[sub 0.5]mn[sub 0.5]o[sub 3−δ]∕ni Coimpregnated Yttria-Stabilized Zirconia Anodes Operated on Liquefied Petroleum Gas Flame

A High-Performance Flame Fuel Cell Using Ethanol As Fuels

A High-Performance No-Chamber Fuel Cell Operated on Ethanol Flame

Experimental study of a solid oxide fuel cell afterburner for a 30 kW generator module: A comparative performance analysis

Biogas-Fueled Flame Fuel Cell for Micro-Combined Heat and Power System

A no chamber fuel cell using ethanol as flame

Experimental investigation of temperature distribution in solid oxide fuel cells

Enhanced Performance of a Single-Chamber Solid Oxide Fuel Cell with Dual Gas Supply Method

Highly Thermal-integrated Flame Fuel Cell Module with High Temperature Heatpipe

Thermal Shock Resistance and Failure Probability Analysis on Solid Oxide Electrolyte Direct Flame Fuel Cells

An Experimental Evaluation of the Temperature Gradient in Solid Oxide Fuel Cells

Micro-tubular Solid Oxide Fuel Cell Stack Operated with Catalytically Enhanced Porous Media Fuel-Rich Combustor

Direct liquid methanol-fueled solid oxide fuel cell