Abstract:The utilization of the exhaust gas of a solid oxide fuel cell is important to improve the energy efficiency and control pollutant emission. In this work, the combustion of solid oxide fuel cell exhaust gas (H 2 /CO) in a honeycomb ceramic catalytic burner is investigated numerically. A 2D numerical combustion model with 17 channels is built to analyze the influence of channel position on thermal performance and combustion characteristics. The high burnout of H 2 and CO is obtained as 96.75% and 97.75%, respectively. The channels can be divided into three groups from the inside to the outside as follows: part 1, from the 9th channel to the 13th channel; part 2, from the 14th channel to the 16th channel; and part 3, the 17th channel. The channels in the same group presented the same results of flow, temperature, and combustion. Compared with the other channels, the outermost channel shows notable differences in depressing the temperature of the whole channel, moving the maximum temperature downstream, enlarging the temperature bias of the lower and upper walls, and enlarging the combustion zone. H 2 and CO perform different combustion processes in the honeycomb ceramic catalytic burner. Compared with H 2 , the initial position of CO conversion is more affected by channel distribution. In the 17th channel, the CO oxidation rate is controlled mostly by the slower oxygen adsorption and the resulting low O(s) coverage. In the 9th channel, the CO oxidation rate is controlled mostly by the wall temperature and fuel-limited. The burnout rate of H 2 changes from 95% to 99.9% with the channel position, but the burnout of CO varies little. The closer the channel to the outer wall, the higher the proportion of heterogeneous reaction and the more the generated heat. The generated heat by the channel can present a diversity of 4%.

Power and Heat Co-Generation by Micro-Tubular Flame Fuel Cell on a Porous Media Burner

Biogas-Fueled Flame Fuel Cell for Micro-Combined Heat and Power System

Performance Characteristics of a Micro-tubular Solid Oxide Fuel Cell Operated with a Fuel-rich Methane Flame

Experimental Characterization of a Direct Methane Flame Solid Oxide Fuel Cell Power Generation Unit

Micro-tubular Solid Oxide Fuel Cell Stack Operated with Catalytically Enhanced Porous Media Fuel-Rich Combustor

Catalytically Enhanced Methane-Rich Combustion by Porous Media Reactor

Direct Flame Fuel Cell Performance Using A Multi-Element Diffusion Flame Burner

Flat-chip Flame Fuel Cell Operated on a Catalytically Enhanced Porous Media Combustor

Integration of Solid Oxide Fuel Cells with Multi-Element Diffusion Flame Burners

Methane/Air Fuel-Rich Combustion in a Catalyst Enhanced Two-Layer Porous Media Burner

Numerical investigation on the exhaust gas combustion of an SOFC in a catalytic multichannel burner

Mathematical Modeling of a Porous Media Burner Based Methane Flame Fuel Cell

Numerical Study on the Characteristics of Methane Hedging Combustion in a Heat Cycle Porous Media Burner

Experimental study of a solid oxide fuel cell afterburner for a 30 kW generator module: A comparative performance analysis

Combustion and Direct Energy Conversion Inside a Micro-Combustor

Start-Up and Operation Characteristics of A Flame Fuel Cell Unit

Elementary Reaction Modeling and Experimental Characterization on Methane Partial Oxidation within a Catalyst-Enhanced Porous Media Combustor

A Direct Flame Solid Oxide Fuel Cell for Potential Combined Heat and Power Generation

Methane Partial Oxidation in a Two-Layer Porous Media Burner with Al2O3 Pellets of Different Diameters

Oxy-combustion of Coal in Liquid-Antimony-anode Solid Oxide Fuel Cell System

The Thermal Effects of All Porous Solid Oxide Fuel Cells