Abstract:Solid oxide electrolysis cells (SOECs) enable the integration of H2O/CO2 co-electrolysis and methanation reactions in a single reactor. The product gas may therefore potentially be sent directly to the existing natural gas pipelines. However, current power-to-methane (P2M) routes are not able to achieve acceptable CO2-to-CH4 conversion in a single SOEC reactor for direct integration into natural gas networks. In order to obtain higher CO2-to-CH4 conversions, a two-dimensional multiscale electro-thermo tubular SOEC model was developed to describe in detail the P2M processes along the whole cell and optimize the materials, flow modes, and operating conditions for CH4 production. The numerical simulations revealed that the stabilized Zr-based SOEC is unable to offer a sufficiently high electrochemical performance at methanation-favoring temperatures (250-650 degrees C). Such a temperature mismatch limits the peak CH4 production ratio in the tubular-stabilized Zr-based SOEC (with an inlet CO2 content of 20%) to only 13% at 1.5 V. In contrast, a tubular strontium and magnesium doped lanthanum gallate (LSGM)-based SOEC showed remarkable performance at or below 650 degrees C, improving the CH4 production ratio to over 50% at 550 degrees C and 1.3 V for the same inlet gas composition. However, the operating temperature was still too high to obtain an acceptable CO2-to-CH4 conversion for direct supply to natural gas pipelines. The model revealed that the H2O/CO2 co-electrolysis and methanation reactions can be synchronously enhanced by feeding a cold gas in counter-flow mode under pressurized conditions. At 29 bar, the tubular LSGM-based SOEC could achieve a CO2-to-CH4 conversion ratio of 98.7%, with an electricity-to-gas efficiency of 94.5% in the thermal neutral mode. The produced gas can be directly sent to the existing natural gas pipelines so that the curtailed renewable power can be stored more efficiently and utilized over a wider area.

Fabrication and Operation of Flow‐through Tubular SOFCs for Electric Power and Synthesis Gas Cogeneration from Methane

Pressurized Tubular Solid Oxide H2O/CO2 Coelectrolysis Cell for Direct Power‐to‐methane

High-rate Electrochemical Partial Oxidation of Methane in Solid Oxide Fuel Cells

Geometric Synergy of Steam/Carbon Dioxide Co-electrolysis and Methanation in a Tubular Solid Oxide Electrolysis Cell for Direct Power-to-Methane

Syngas/power Cogeneration from Proton Conducting Solid Oxide Fuel Cells Assisted by Dry Methane Reforming: A Thermal-Electrochemical Modelling Study

Performance Characteristics of a Micro-tubular Solid Oxide Fuel Cell Operated with a Fuel-rich Methane Flame

Autothermal reforming of methane over an integrated solid oxide fuel cell reactor for power and syngas co-generation

Direct Operation of Solid Oxide Fuel Cells on Low-Concentration Oxygen-Bearing Coal-Bed Methane with High Stability

A cofuel channel microtubular solid oxide fuel/electrolysis cell

Synchronous Enhancement of H2O/CO2 Co-Electrolysis and Methanation for Efficient One-Step Power-to-methane

High Performance Tubular Solid Oxide Fuel Cells With Bscf Cathode

Power and Heat Co-Generation by Micro-Tubular Flame Fuel Cell on a Porous Media Burner

Biogas-Fueled Flame Fuel Cell for Micro-Combined Heat and Power System

Methane Production and Electricity Generation in a Proton Conducting Tubular Reversible Solid Oxide Cell

Experimental Characterization of a Direct Methane Flame Solid Oxide Fuel Cell Power Generation Unit

Direct Operation of Solid Oxide Fuel Cells with Methane Fuel

A Novel Design of Single-Chamber SOFC Micro-Stack Operated in Methane–oxygen Mixture

The Performance of a Single-Chamber Solid Oxide Fuel Cell Operated under Thin Oxygen Condition Within Methane Fuel

80 Hours operation of a tubular solid oxide fuel cell using propane/air

Performance Evaluation of Solid Oxide Fuel Cell with In-Situ Methane Reforming

Electrochemical Properties of Tubular SOFC Based on a Porous Ceramic Support Fabricated by Phase-Inversion Method