Abstract:Solid oxide fuel cell (SOFC) is a clean and efficient power generation device, which has been widely used in recent years. However, its operation lifetime still needs to be improved to meet the requirements for further commercialization. The performance degradation of SOFCs is affected by many factors. It is very important to distinguish these factors and determine the dominant factor(s) for improving the operation lifetime in a more efficient manner. In this paper, the initial operation stage (<100 h) of SOFCs is mainly focused, in which the electrochemical performance changes most significantly. The electrochemical impedance spectroscopy (EIS) was periodically monitored during the operation process. Individual electrode processes of button cells and industrial-size cells were distinguished via distribution of relaxation time (DRT) method and subsequent equivalent circuit model (ECM) fitting. Through detailed time-varying analysis of EIS, the changes of different electrode processes in the initial-stage operation were obtained, and the evolution mechanism of electrochemical performance was proposed. After reduction, SOFCs go through activation stage and aging stage in turn: i) In the activation stage, the anode porosity increases and the gas-phase diffusion process is enhanced, resulting in the improvement of cell performance. ii) In the aging stage, the Ni particles in the anode agglomerate, so the effective three phase boundary (TPB) density decreases, which leads to the degradation of anode charge transfer reaction and the drop of cell performance. This evolution mechanism of electrochemical performance was partially confirmed by detailed microstructure characterization. It should be mentioned that the duration of each stage and the performance change in each stage can be affected by the initial electrode structure. Therefore, in previous studies, it was observed that some cells did not show activation process during initial-stage operation, but directly entered the aging stage. Besides, during longer-term operation of the cell (>100 h), we speculate that the dominant degradation mechanism is the continuous increase of the anode interface reaction-related resistance, which is caused by the agglomeration of Ni particles. However, since the anode structure is gradually stable, the degradation rate of cell performance decreases with respect to the operation time.

Electrochemical characterization and degradation analysis of a flat-chip solid oxide fuel cell fed by ambient temperature inlet gas

Solid Oxide Electrolysis Cell under Real Fluctuating Power Supply with a Focus on Thermal Stress Analysis

Towards Feasible Temperature Management and Thermo-Mechanical Stability of Carbon-Assisted Solid Oxide Electrolysis Cell

Experimental investigation of temperature distribution in solid oxide fuel cells

Spatially resolved electrochemical performance and temperature distribution of a segmented solid oxide fuel cell under various hydrogen dilution ratios and electrical loadings

Initial-Stage Performance Evolution of Solid Oxide Fuel Cells Based on Polarization Analysis

Performance Degradation Analysis of Solid Oxide Fuel Cells Using Dynamic Electrochemical Impedance Spectroscopy

An Experimental Evaluation of the Temperature Gradient in Solid Oxide Fuel Cells

Low Temperature Solid Oxide Fuel Cells with Hierarchically Porous Cathode Nano-Network

Identification of Restricting Parameters on Steps toward the Intermediate-Temperature Planar Solid Oxide Fuel Cell

Evolution of Electrochemical Characteristics of Solid Oxide Fuel Cells During Initial-Stage Operation

Quantifying the performance evolution of solid oxide fuel cells during initial aging process

Performance and Electrochemical Analysis of Solid Oxide Fuel Cells Based on LSCF‐YSZ Nano‐electrode

Degradation of Solid Oxide Fuel Cell Using Thin Film Electrodes Fueled By Carbon Monoxide-Hydrogen Syngas

Analysis on temperature uniformity in methane-rich internal reforming solid oxide fuel cells (SOFCs)

In-situ Analysis of Anode Atmosphere in a Flat-Tube Solid Oxide Fuel Cell Operated with Dry Reforming of Methane

Analytically Investigating the Characteristics of a High-Temperature Unitized Regenerative Solid Oxide Fuel Cell

Electrochemical Characterization on SDC/Na2CO3 Nanocomposite Electrolyte for Low Temperature Solid Oxide Fuel Cells

Thermal Shock Resistance and Failure Probability Analysis on Solid Oxide Electrolyte Direct Flame Fuel Cells

High-Performance Low-Temperature Solid Oxide Fuel Cell with a Pt@C–Ni 0.8 Co 0.15 Al 0.05 LiO 2−δ Composite Cathode

Development of Solid Oxide Fuel Cell Materials for Intermediate-to-low Temperature Operation