Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Test Methods For Fpga Switching Characteristics On Gpete Test Platform

Design Of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter For Modern Fpgas At 10mhz

FATE: A Flexible FPGA-Based Automatic Test Equipment for Digital ICs

Design for HW/SW Co-Testing Based on FPGA

A New Configuration Scheme for Delay Test in Non-Simple LUT FPGA Designs

An FPGA-based system for generalised electron devices testing

Method and system for testing on site programmable gate array

Analyse of Protection Devices' Speed Performance against ESD under CDM Using TCAD

Romote Test System of FPGA based on USB and LVDS

Low-Cost Multi-Gigahertz Test Systems Using CMOS FPGAs and PECL

A New Automatic Method for Testing Interconnect Resources in Fpgas Based on General Routing Matrix

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

Design And Implementation Of Cpu & Fpga Co-Design Tester For Sdn Switches

A Power Efficient BIST TPG Method on Don't Care Bit Based 2-D Adjusting and Hamming Distance Based 2-D Reordering

The design of a time-interleaved analog-digital conversion modulator based on FPGA-TDC for PET application

Testing and Diagnosis for Both Interconnect Resources and CLBs in Virtex Series FPGAs

New Techniques for Accelerating Small Delay ATPG and Generating Compact Test Sets

Research On Design And Test Method Of High Performance 6 Input Lut

Chip Tester Based on FPGA Commonly Used in Laboratory

Testing Methods for Detecting Stuck-Open Power Switches in Coarse-Grain MTCMOS Designs

A Universal Automatic On-Chip Measurement Of Fpga'S Internal Setup And Hold Times