Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Testing Methods for Detecting Stuck-Open Power Switches in Coarse-Grain MTCMOS Designs

Analysis of Smart Power IC TOPSwitch

An Efficient Hamiltonian-cycle Power-Switch Routing for MTCMOS Designs.

Using Nmos Transistors As Switches For Accuracy And Area-Efficiency In Large-Scale Addressable Test Array

An improved method for test chip design

Comparison of different MOS-triggered SCR structures for on-chip ESD protection

A novel power-clamp assisted complementary MOSFET for robust ESD protection.

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

Investigation of Esd Protection Strategy in High Voltage Bipolar-Cmos-Dmos Process

A Novel Gate Control Strategy for 3.4kv Cascade Sic Mosfets Stack

Analysis and Suppression for Crosstalk in SiC MOSFET Turn-off Transient

Comparative Investigation on Aging Precursor and Failure Mechanism of Commercial SiC MOSFETs Under Different Power Cycling Conduction Modes

Low Power Computing Using STT-MRAM

Gate Drive Technology Evaluation and Development to Maximize Switching Speed of SiC Discrete Devices and Power Modules in Hard Switching Applications

Impacts of the MTCMOS technology on power supply network: a full-chip perspective

Research on single event latch-up effect of CMOS based on TCAD

A Novel Scan Segmentation Design for Power Controllability and Reduction in At-Speed Test.

The Failure Mechanism of Gate Resistance Testing for Power MOSFET

Test Methodology for Short-Circuit Assessment and Safe Operation Identification for Power SiC MOSFETs

Leakage power reduction in flip flops by using MTCMOS and ULP switch

Time-Domain and Frequency-Domain Analysis of SiC MOSFET Switching Transients Considering Transmission of Control, Drive, and Power Pulses