Abstract:Multi-threshold CMOS is a valuable leakage reduction method in circuit standby mode. Reducing leakage current through fine-grain sleep transistor insertion (FGSTI) makes it easier to guarantee circuit functionality and improves circuit noise margins. In this paper, we first indicate the negligible dependence of ST size on the amount of leakage saving which makes the two-phase FGSTI reasonable based on our leakage current and delay models. Then we introduce a novel two-phase FGSTI technique: a) ST placement and b) ST sizing, which are formally modeled as two linear programming (LP) models respectively. Our experimental results show that the two-phase FGSTI technique can achieve 78.91%, 92.55%, 97.97% leakage saving when the circuit slowdown is 0%, 3%, 5% respectively. Comparing to the simultaneous ST placement and sizing method using mix integer linear programming (MLP) [1], our technique leads to on average 2% more leakage current reduction while at least 10X runtime saving since fewer variables and constraints with less approximation are used in the LP models. When the circuit slowdown is large enough to perform conventional fixed slowdown method, our technique can still achieve 75.48% ST area saving. Moreover, we show that when the circuit slowdown is 0%, it should be carefully considered to use FGSTI technique due to a large amount of leakage feedback gates.

Impacts of the MTCMOS technology on power supply network: a full-chip perspective

Design and Validate the Chip's Power-Network in DSM

Design of the Power Management Module Integrated in SOC

An MTCMOS Technology for Low-Power Physical Design

Sleep Transistor Sizing for Multi-Threshold-voltage Network Using Lagrange SOR Iteration

Modeling of Power Distribution Network Based on Multi-Walled Carbon Nanotube TSVs for 3-D ICs

Research on low power technology based on Multi Bit Flip Flop

Ground Bouncing Noise Reduction Technique Considering Wake-Up Delay in MTCMOS Circuits

1-V power supply high-speed digital circuit technology with multithreshold-voltage CMOS

Simultaneous Fine-grain Sleep Transistor Placement and Sizing for Leakage Optimization

Leakage power reduction in flip flops by using MTCMOS and ULP switch

The Impact of Device Scaling and Power Supply Change on CMOS Gate Performance

Gate Oxide and Implantation Process Co-Optimization for Low-Power MCU Applications

Two-phase Fine-grain Sleep Transistor Insertion Technique in Leakage Critical Circuits

Testing Methods for Detecting Stuck-Open Power Switches in Coarse-Grain MTCMOS Designs

A Low Power Localized 2T1R STT-MRAM Array with Pipelined Quad-Phase Saving Scheme for Zero Sleep Power Systems.

Design of CMOS low-power pre-settable edge-triggered flip-flop based on multithreshold technique.

EXPERIMENTAL STUDY AND SPICE SIMULATION OF CMOS INVERTERS LATCH-UP EFFECTS DUE TO HIGH POWER MICROWAVE INTERFERENCE

An Efficient Hamiltonian-cycle Power-Switch Routing for MTCMOS Designs.

Power-switch routing for reducing dynamic IR drop in multi-domain MTCMOS designs

Power Optimization Techniques in CMOS IC Design