Abstract:A triple-active bridge (TAB) can be used as a power conversion unit in a three-port DC energy router (DCER) such as a triple-active bridge-based DC energy router (TAB-DCER). The operational loss of a TAB can be seen as a key factor affecting the efficiency of a TAB-DCER. However, the RMS value of the inductor current of the TAB-DCER increases under single-phase shift (SPS) control, and this greatly increases the system operating losses. The use of phase-shifted plus PWM (PS-PWM) control can reduce the RMS value of the inductor current, but its mathematical model is complex, and involves difficult calculations. To address this problem, in the study reported here, we developed an optimal control strategy for the RMS value of the inductor current based on TAB-DCER. First, the working principle of a TAB-DCER under PS-PWM control was analyzed, and a circuit decomposition model was established. Second, the operating modes under PS-PWM control were analyzed, and corresponding expressions of port power and the RMS value of the inductor current were obtained. Third, an optimized mathematical model of the sum of squares of the RMS value of the inductor current of the TAB-DCER was constructed. Finally, a genetic algorithm was used to solve the mathematical model and derive the optimal phase shift angle; this resulted in a lower RMS value of the inductor current in the TAB-DCER and reduced the system operating losses. The simulation and experimental results show that the TAB-DCER used in the present study can reduce operating losses, improve system efficiency, and deliver coordinated power control.

Power-switch routing for reducing dynamic IR drop in multi-domain MTCMOS designs

An Efficient Hamiltonian-cycle Power-Switch Routing for MTCMOS Designs.

Design and Validate the Chip's Power-Network in DSM

A routing framework for technology migration with bump encroachment

A novel cross-layer framework for early-stage power delivery and architecture co-exploration.

Suppression Switching Ringing of SiC-MOSFET Inverters with Combined Design of DC Bus Snubber and Gate Drive

In-package P/G Planes Analysis and Optimization Based on Transmission Matrix Method

Effective Resistance Approach for DC Analysis of Power Grid on Through-Silicon Interposer (TSI)

An MTCMOS Technology for Low-Power Physical Design

Multi-Domain Modeling and Design Optimization of Synchronous Rectifiers for SiC-Based High- Load-Current LLC Converter

High Order Distribute Circuit Model of Laminated Busbars and Its Order Reduction Techniques for Simulating Fast Turn-on and Turn-off Transients

Reduced Switching-Frequency Modulation and Circulating Current Suppression for Modular Multilevel Converters

DISTRIBUTED MULTICONTACT RF MEMS SWITCH FOR POWER HANDLING CAPABILITY IMPROVEMENT

Impacts of the MTCMOS technology on power supply network: a full-chip perspective

IR-drop reduction through combinational circuit partitioning

A Power-Aware Adaptive Routing Scheme for Network on a Chip

Cancellation of Power-Gate Mutual Inductance for Crosstalk Voltage Alleviation in SiC MOSFET Multi-chip Power Modules

Energy Efficient Design for Multi-Shelf IP over WDM Networks

An Efficiency Improvement Strategy for Triple-Active-Bridge-Based DC Energy Routers in DC Microgrids

Multicell Reconfigurable Multi-Input Multi-Output Energy Router Architecture

Design and Analysis of Power Integrity in Deep Submicron System-on-Chip Circuits