Abstract:For the battery- or USB-powered portable smart devices, which supply their computing cores with a wide-range sub-volt rail, the energy-efficient high and wide voltage-conversion-ratio (VCR) converters are crucially important. In addition, low form factor and decent transient responses are also favorable for such applications. Prior state-of-the-art designs either use single-stage hybrid designs using multi-level or Dickson converters [1 – 3], or adopt two-stage cascaded architectures with a highly efficient unregulated front (or rear) stage [4], as shown in Fig. 18.6.1 (left). The multi-level designs, which conduct the full inductor current through all the on-state switches, are suited to low-to-medium power levels with limited current density. The Dickson converters take advantage of a high conversion ratio, however, at the cost of reduced output voltage range. The two-stage designs which show decent output range and efficiency, however, can suffer from heavy load efficiency degradation considering that the efficiency of both stages degrade with increasing load and the overall efficiency which is the product of the efficiencies of the two stages is severely degraded. Inspired by the inductive-sigma converter [5] which shunts a highly efficient unregulated LLC with a regulated Buck, this work proposes a reconfigurable capacitive-sigma converter. By input-series and output-shunting a highly efficient unregulated switched-capacitor (SC) converter with a reconfigurable Dickson hybrid Buck stage, the power stage input current is reused and output currents are combined. Therefore, the overall efficiency is greatly improved in a wide continuous VCR range and with an enhanced loading capacity. Besides, as will be demonstrated, the proposed design shows inherently decent load transient and regulation performances.

Design Of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter For Modern Fpgas At 10mhz

Design of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter for Modern FPGAs at 10Mhz

A GaN-based MHz Active Clamp Flyback Converter with Adaptive Dual Edge Dead Time Modulation for AC-DC Adapters.

A Digital PWM Controller of MHz Active Clamp Flyback with GaN Devices for AC-DC Adapter.

A 2mhz Constant-Frequency AOT V-2 Buck Converter with Adaptive Dead Time Control for Data Centers

A 5V Input 98.4% Peak Efficiency Reconfigurable Capacitive-Sigma Converter with Greater Than 90% Peak Efficiency for the Entire 0.4~1.2V Output Range.

A High-Efficiency 12/1-V Dual-Path Series-Capacitor Converter with Low $v\cdot A$ Metric and Full Duty Range

An 8A 998A/inch<SUP>3</SUP> 90.2% Peak Efficiency 48V-to-1V DC-DC Converter Adopting On-Chip Switch and GaN Hybrid Power Conversion

High Efficiency High Density 1 MHz 380–12 V DCX with Low FoM Devices

A 12/24 V-to-sub-1 V Double Step-down Converter with Dual-ramp Control for VCF Balancing and Fast Transient Response

FPGA Performance Optimization Plan for High Power Conversion

Adaptive Charge-Compensation-Based Variable On-Time Control to Improve Input Current Distortion for CRM Boost PFC Converter

A Monolithic GaN Power Stage with Low Propagation Delay and High Reliability Level Shifting for High Frequency Power Converter.

An Auxiliary Switched-Capacitor Power Converter (Scpc) Applied In Stacked Digital Architecture For Energy Utilization Enhancement

A 1-MHz switched-inductor-based high-step-up converter with optimized integrated magnetics

Design of a High-Precision Flyback Constant Voltage AC-DC Converter

A 30MHz Delay-Line-Based Buck Converter with 5.7%-94.8% Switching Duty Cycle

Design and Implementation of a Soft-Switching Converter With High Step-Up Ratio

Secondary-Side Phase-Shift-Controlled Zvs Dc/Dc Converter with Wide Voltage Gain for High Input Voltage Applications

High precision scalable power converter for accelerator magnets

Adaptive Dead-Time and Partial-ZVS Regulation for GaN-Based Active Clamp Flyback Converter with Predictive Hysteresis Current Mode Control