Abstract:High-density embedded nonvolatile memory (eNVM) at advanced technology nodes is still in great demand for SOC chips used in consumer electronics, self-driving cars, industrial control, and IoT edge devices. Although embedded NOR Flash is still main stream, its process complexity and high integration cost make it difficult to scale beyond 28nm. RRAM has become a promising alternative owing to its excellent scalability, low power, and compatibility with logic processes [1 –6]. However, several challenges still exist that restrict RRAM from practical eNVM applications, as shown in Fig. 24.2.1. 1) a high supply voltage is needed, because of high operation voltages and a considerable voltage drop on write path. 2) The IR drop on write path varies significantly with the distance of a cell from the peripheral circuits. 3) Prior self-write termination (SWT), with its abrupt cutoff, fails to form dense conductive filaments (CFs). While delayed termination helps to alleviate this issue, its delay time is not optimized for fast and slow cells [3]. 4) Previous read reference schemes that use a small number of HRS/LRS cells may collapse when encountering tail bits, resulting in a poor reference [6]. In this work, we demonstrate a 1Mb 14nm-FinFET RRAM with a $0.022 \\mu m^{2}$ cell size. The cell array is in a deep N-well with adequate P-substrate biasing to alleviate the difficulty of high voltage transfer. Placing the bit line (BL) and source line (SL) drivers on the top and bottom of the array reduces the IR-drop variation for near and far cells. Self-adaptive delayed termination (SADT) adjusts the termination time according to cell characteristics (fast or slow), helping to generate robust CFs. A read reference with multiple dummy 1T1R cells avoids the reference collapse issue. The test chip supports reliable read operation at a minimum supply voltage of 0.5V from $-40^{\\circ}C$ to $125^{\\circ}C$.

A ReRAM-based Single-Nvm Nonvolatile Flip-Flop with Reduced Stress-Time and Write-Power Against Wide Distribution in Write-Time by Using Self-Write-termination Scheme for Nonvolatile Processors in IoT Era

A ReRAM-Based Nonvolatile Flip-Flop With Self-Write-Termination Scheme for Frequent-OFF Fast-Wake-Up Nonvolatile Processors.

4.7 A 65nm ReRAM-enabled nonvolatile processor with 6× reduction in restore time and 4× higher clock frequency using adaptive data retention and self-write-termination nonvolatile logic

A 65-Nm ReRAM-Enabled Nonvolatile Processor with Time-Space Domain Adaption and Self-Write-Termination Achieving $> 4\times $ Faster Clock Frequency and $> 6\times $ Higher Restore Speed

Simulation of the RRAM-based flip-flops with data retention

A Low-Power Low-VDD Nonvolatile Latch Using Spin Transfer Torque MRAM

A 462gops/j RRAM-based Nonvolatile Intelligent Processor for Energy Harvesting IoE System Featuring Nonvolatile Logics and Processing-in-memory

Advancing Nonvolatile Computing with Nonvolatile NCFET Latches and Flip-Flops.

An 8t/cell FeFET-Based Nonvolatile SRAM with Improved Density and Sub-fJ Backup and Restore Energy

A Self-Adaptive Write Driver with Fast Termination of Step-Up Pulse for Reram

Lowering Area Overheads for FeFET-Based Energy-Efficient Nonvolatile Flip-Flops

A 14nm-Finfet 1mb Embedded 1t1r Rram With A 0.022 Mu M(2) Cell Size Using Self-Adaptive Delayed Termination And Multi-Cell Reference

A 0.13 mu m 64Mb HfOx ReRAM Using Configurable Ramped Voltage Write and Low Read-Disturb Sensing Techniques for Reliability Improvement

A 0.13μm 64Mb HfO<inf>x</inf> ReRAM using configurable ramped voltage write and low read-disturb sensing techniques for reliability improvement

24.2 A 14nm-FinFET 1Mb Embedded 1T1R RRAM with a 0.022µm<sup>2</sup> Cell Size Using Self-Adaptive Delayed Termination and Multi-Cell Reference

Challenges at circuit designs for resistive-type Nonvolatile memory and nonvolatile logics in mobile and cloud applications

Design of Nonvolatile SRAM with Ferroelectric FETs for Energy-Efficient Backup and Restore

Efficient and Robust Nonvolatile Computing-In-Memory Based on Voltage Division in 2T2R RRAM with Input-Dependent Sensing Control

A 130-Nm Ferroelectric Nonvolatile System-on-Chip with Direct Peripheral Restore Architecture for Transient Computing System

Highly Compact 1T-1R Architecture (4f(2) Footprint) Involving Fully Cmos Compatible Vertical Gaa Nano-Pillar Transistors and Oxide-Based Rram Cells Exhibiting Excellent Nvm Properties and Ultra-Low Power Operation

A 3us wake-up time nonvolatile processor based on ferroelectric flip-flops