Abstract:Energy-harvesting internet-of-things devices must deal with unstable power input. Nonvolatile processors (NVPs) can offer an effective solution. Compact and low-energy arithmetic circuits that can efficiently switch between computation and backup operations are highly desirable for NVP design. This paper introduces a nonvolatile ferroelectric field-effect transistors (FeFET)-based sequential multiplier with the ability to do continued calculation after a power outage, thus achieving zero backup overhead. We exploit the unique characteristics of FeFETs to construct key components of a sequential multiplier. The multiplier relies on a FeFET-based adder and a new FeFET-based latch to achieve compact area and low operating energy. Moreover, it uses the hysteretic characteristic of FeFETs to realize the storage capability, and hence is able to store, at no extra cost, the intermediate data of an operation in a nonvolatile manner. This property provides support for continued computation when power supplies may be intermittent. Simulation results show that, assuming the same technology node, the proposed FeFET-based multiplier saves up to 21% and 19% area than a conventional CMOS-based sequential multiplier of 4-bits and 8-bits, respectively. It also saves 32% and 73% less area compared with a CMOS-based array multiplier. Furthermore, the proposed design can offer up to 32%/23% energy saving per operation compared with a 4/8-bit CMOS-based sequential multiplier.

A 3us wake-up time nonvolatile processor based on ferroelectric flip-flops

A Ferroelectric Nonvolatile Processor with 46 $\mu $ S System-Level Wake-up Time and 14 $\mu $ S Sleep Time for Energy Harvesting Applications

A 130-Nm Ferroelectric Nonvolatile System-on-Chip with Direct Peripheral Restore Architecture for Transient Computing System

A compare-and-write ferroelectric nonvolatile flip-flop for energy-harvesting applications

Nonvolatile and Energy-Efficient FeFET-Based Multiplier for Energy-Harvesting Devices.

A ReRAM-Based Nonvolatile Flip-Flop With Self-Write-Termination Scheme for Frequent-OFF Fast-Wake-Up Nonvolatile Processors.

A 65-Nm ReRAM-Enabled Nonvolatile Processor with Time-Space Domain Adaption and Self-Write-Termination Achieving $> 4\times $ Faster Clock Frequency and $> 6\times $ Higher Restore Speed

A High-Performance Wordline Voltage-Generating System for Low-Power Low-Voltage Flash Memory

Design of Nonvolatile Processors and Applications

Ambient Energy Harvesting Nonvolatile Processors: from Circuit to System

4.7 A 65nm ReRAM-enabled nonvolatile processor with 6× reduction in restore time and 4× higher clock frequency using adaptive data retention and self-write-termination nonvolatile logic

Nonvolatile processor optimization for ambient energy harvesting scenarios

Advancing Nonvolatile Computing with Nonvolatile NCFET Latches and Flip-Flops.

Nonvolatile Ferroelectric Field-Effect Transistors.

HW/SW Co-Design of Nonvolatile IO System in Energy Harvesting Sensor Nodes for Optimal Data Acquisition

A 130nm FeRAM-based Parallel Recovery Nonvolatile SOC for Normally-off Operations with 3.9× Faster Running Speed and 11× Higher Energy Efficiency Using Fast Power-on Detection and Nonvolatile Radio Controller

Dual Mode Ferroelectric Transistor Based Non-Volatile Flip-Flops for Intermittently-Powered Systems.

Nonvolatile Processor Architectures: Efficient, Reliable Progress with Unstable Power

A ReRAM-based Single-Nvm Nonvolatile Flip-Flop with Reduced Stress-Time and Write-Power Against Wide Distribution in Write-Time by Using Self-Write-termination Scheme for Nonvolatile Processors in IoT Era

A 462gops/j RRAM-based Nonvolatile Intelligent Processor for Energy Harvesting IoE System Featuring Nonvolatile Logics and Processing-in-memory

Efficient Energy Management by Exploiting Retention State for Self-Powered Nonvolatile Processors