Abstract:Multi-gigahertz fundamental repetition rate, tunable repetition rate and wavelength, ultrafast fiber lasers at wavelengths of 1.0, 1.5, and 2.0 µm are experimentally demonstrated and summarized. At the wavelength of 1.0 µm, the laser wavelength is tuned in the range of 1040.1-1042.9 nm and the repetition rate is shifted by 226 kHz in a 3-cm-long all-fiber laser by controlling the temperature of the resonator. Compared with a previous work where the maximum average power was 0.8 mW, the power in this study is significantly improved to 57 mW under a launched pump power of 213 mW, thus achieving an optical-to-optical efficiency of 27%. For comparison, a similar temperature-tuning technique is implemented in a Tm3+-doped ultrafast oscillator but, as expected, it results in a broader tunable range of 14.1 nm (1974.1-1988.2 nm) in wavelength as compared with the value of 1.8 nm for the wavelength of 1.0 µm. The repetition rate in the process is shifted by 294 kHz. For the high-frequency range from 100 kHz to 10 MHz, the value of integrated timing jitter gradually increases with an increase in temperature. Finally, to the best of our knowledge, for the first time, a new method for tuning wavelength and repetition rate is proposed and demonstrated for a femtosecond fiber laser at the wavelength of 1.5 µm. Through fine rotation of the alignment angle between the Er/Yb:glass fiber and a semiconductor saturable absorption mirror, the peak wavelength can be tuned in the range of 1591.4-1586.1 nm and the repetition rate is shifted by 60 kHz.

Ultra High-Repetition-Rate Pulse Sources Based on Cascaded Four Wave Mixing in EYDF

Photonic Generation of Ultrawideband Monocycle and Doublet Pulses by Using a Semiconductor-Optical-amplifier-based Wavelength Converter.

Widely tunable, high-repetition-rate, dual signal-wave optical parametric oscillator by using two periodically poled crystals

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

All-Fiber High Repetition Rate Short Pulse Generation Around 1030Nm

Widely Tunable Ultrafast Sources For Multi-Photon Microscopy

Widely tunable sub-30-fs pulses from a compact erbium-doped fiber source

Tunable Single‐to‐dual Channel Wavelength Conversion of Picosecond Pulses Based on Four‐wave Mixing in Microstructure Fibers

3-Ghz, Ultrafast Yb-fiber Laser Sources: Closing the Spectral Gaps

A Simple 10-Ghz Picosecond Pulse Source Based on Fiber Optical Parametric Oscillator

An ultrafast electro-optic light source with sub-cycle precision

2- $\mu$ M Repetition-Rate Tunable (1–6 GHz) Picosecond Source

3 GHz, Yb-fiber laser-based, few-cycle ultrafast source at the Ti:sapphire laser wavelength

High-energetic ultrafast fiber laser sources tunable from 920 to 1030 nm based on tapered photonic crystal fibers

Cascaded Nondegenerate Four-Wave Mixing Technique for High-Power Single-Cycle Pulse Synthesis in the Visible and Ultraviolet Ranges

High-repetition-rate Ultrafast Fiber Lasers.

Direct Generation of 148 nm and 44.6 fs Pulses in an Erbium-Doped Fiber Laser

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

Generation of sub-30 fs pulses from an erbium-doped fiber amplifier at 203 MHz repetition rate

Pulse Energy Scaling by Optimizing Cavity Management in Low Repetition Rate Erbium-Doped Fiber Femtosecond Lasers

Terahertz Repetition Rate Pulse Generation In Erbium-Ytterbium Co-Doped Fiber