Abstract:An exciting recent development for deep-tissue imaging with cellular resolution is three-photon fluorescence microscopy (3PM) with excitation at long wavelengths (1300 and 1700 nm). In the last few years, long-wavelength 3PM has driven rapid progress in deep-tissue imaging beyond the depth limit of two-photon microscopy, with impacts in neuroscience, immunology, and cancer biology. However, wide adoption of 3PM faces challenges. Three-photon excitation (3PE) is naturally weaker than two-photon excitation, which places a premium on ultrashort pulses with high peak power. The inefficiency, complexity, and cost of current sources of these pulses present major barriers to the use of 3PM in typical biomedical research labs. Here, we describe a fiber-based source of femtosecond pulses with multi-megawatt peak power, tunable from 850 nm to 1700 nm. Compressed pulses from a fiber amplifier at 1030~nm are launched into an antiresonant hollow-core fiber filled with argon. By varying only the gas pressure, pulses with hundreds of nanojoules of energy and sub-100 fs duration are obtained at wavelengths between 850 and 1700 nm. This approach is a new route to an efficient, robust, and potentially low-cost source for multiphoton deep-tissue imaging. In particular, 960-nJ and 50-fs pulses are generated at 1300 nm with a conversion efficiency of 10\%. The nearly 20-MW peak power is an order of magnitude higher than the previous best from femtosecond fiber source at 1300~nm. As an example of the capabilities of the source, these pulses are used to image structure and neuronal activity in mouse brain as deep as 1.1 mm below the dura.

Fiber-Based High-Energy Femtosecond Pulses Tunable from 920 to 1030 Nm for Two-Photon Microscopy

High-energetic ultrafast fiber laser sources tunable from 920 to 1030 nm based on tapered photonic crystal fibers

High energy (> 40 nJ), sub-100 fs, 950 nm laser for two-photon microscopy

Low noise, self-phase-modulation-enabled femtosecond fiber sources tunable in 740-1236 nm for wide two-photon fluorescence microscopy applications

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

Widely Tunable Ultrafast Sources For Multi-Photon Microscopy

Femtosecond Fiber Laser at 780 Nm for Two-Photon Autofluorescence Imaging

Femtosecond Mode-locked Fiber Laser at 1 Μm Via Optical Microfiber Dispersion Management

256 MHz, 1 W 780 Nm Femtosecond Fiber Laser for Two-Photon Microscopy

950 Nm Femtosecond Laser by Directly Frequency-Doubling of a Thulium-Doped Fiber Laser

Optical Microfiber-Based Ultrafast Fiber Lasers

High-energy 100-ns single-frequency all-fiber laser at 1064 nm

3 GHz, Yb-fiber laser-based, few-cycle ultrafast source at the Ti:sapphire laser wavelength

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

Robust Hollow-Fiber-pigtailed 930 Nm Femtosecond Nd:fiber Laser for Volumetric Two-Photon Imaging.

Watt-level all polarization-maintaining femtosecond fiber laser source at 1100 nm for multicolor two-photon fluorescence excitation of fluorescent proteins

Efficient, broadly-tunable source of megawatt pulses for multiphoton microscopy based on self-phase modulation in argon-filled hollow-core fiber

Fiber-optic nonlinear wavelength converter for adaptive femtosecond biophotonics

High-energy Femosecond Laser Sources Tunable from 920 to 1030 Nm Based on Tapered Photonic Crystal Fibers - Withdrawn

Efficient Green-Light Generation by Frequency Doubling of a Picosecond All-Fiber Ytterbium-Doped Fiber Amplifier in PPKTP Waveguide Inscribed by Femtosecond Laser Direct Writing

Microjoule-level mid-infrared femtosecond pulse generation in hollow-core fibres