Abstract:We propose and demonstrate a new approach to implement a wavelength-tunable ultrafast fiber laser source suitable for multiphoton microscopy. We employ fiber-optic nonlinearities to broaden a narrowband optical spectrum generated by an Yb-fiber laser system and then use optical bandpass filters to select the leftmost or rightmost spectral lobes from the broadened spectrum. Detailed numerical modeling shows that self-phase modulation dominates the spectral broadening, self-steepening tends to blue shift the broadened spectrum, and stimulated Raman scattering is minimal. We also find that optical wave breaking caused by fiber dispersion slows down the shift of the leftmost/rightmost spectral lobes and therefore limits the wavelength tuning range of the filtered spectra. We show both numerically and experimentally that shortening the fiber used for spectral broadening while increasing the input pulse energy can overcome this dispersion-induced limitation; as a result, the filtered spectral lobes have higher power, constituting a powerful and practical approach for energy scaling the resulting femtosecond sources. We use two commercially available photonic crystal fibers to verify the simulation results. More specific, use of 20-mm fiber NL-1050-ZERO-2 enables us to implement an Yb-fiber laser based ultrafast source, delivering femtosecond (70-120 fs) pulses tunable from 825 nm to 1210 nm with > 1 nJ pulse energy. (C) 2016 Optical Society of America

3 GHz, Yb-fiber laser-based, few-cycle ultrafast source at the Ti:sapphire laser wavelength

3 GHz few-cycle ultrafast source at 850nm

3-Ghz, Ultrafast Yb-fiber Laser Sources: Closing the Spectral Gaps

3 GHz, Fundamentally Mode-Locked, Femtosecond Yb-fiber Laser.

Compact High-Power Multiwavelength Photonic-Crystal-fiber-based Laser Source of Femtosecond Pulses in the Infrared–visible–ultraviolet Range

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

Femtosecond Mode-locked Fiber Laser at 1 Μm Via Optical Microfiber Dispersion Management

97-Watt, 1.08-Gigahertz Repetition Rate, Femtosecond Yb:fiber Laser Source

Sub-30 Fs Yb-fiber Laser Source Based on a Hybrid Cascaded Nonlinear Compression Approach

High-energetic ultrafast fiber laser sources tunable from 920 to 1030 nm based on tapered photonic crystal fibers

Gigahertz-repetition rate, high power, ultrafast Tm-doped fiber laser source

Fiber-Based High-Energy Femtosecond Pulses Tunable from 920 to 1030 Nm for Two-Photon Microscopy

Old Wavelength, New Performance: Hectowatt 200-μJ-level Femtosecond fiber CPA System at 1064 Nm

High-Power GHz Burst-Mode All-Fiber Laser System with Sub 300 fs Pulse Duration

3 Ghz, Femtosecond Raman Soliton Source

An All-Fiber Supercontinuum Source with 30.6-W High-Power and Ultrawide Spectrum Ranging from 385 Nm to Beyond 2400 Nm

The Design of >2000-nm, ∼100-MHz Ultrafast Tm-Doped Fiber Soliton Laser Source

Low noise, self-phase-modulation-enabled femtosecond fiber sources tunable in 740-1236 nm for wide two-photon fluorescence microscopy applications

Compact and High-Power Broadband Terahertz Source Based on Femtosecond Photonic Crystal Fiber Amplifier

Strictly all-fiber picosecond ytterbium fiber laser utilizing chirped-fiber-Bragg-gratings for dispersion control

> 10 GHz femtosecond fiber laser system at 2.0 m