Abstract:Synthesis of blue organic light-emitting materials is very important for practical applications of(organic) light-emitting diodes(OLEDs).Organometallic complex lithium tetra-(8-hydroxy-quinolinato) boron(LiBq_4) was synthesized,purified and used as light-emitting material.Blue ITO/PVK∶TPD/LiBq_4/Alq_3/Al OLED was fabricated adopting spin and vacuum deposition,and the electroluminescence spectrum was(measured) at different operation voltage.At the same time,the influence of thickness of Alq_3,CuPc and LiF on the luminescence properties of blue OLEDs was studied.Results indicated that,the peak wavelength of(fluorescence) spectrum for LiBq_4 is about 452 nm under excitation of 350 nm.The peak wavelength of(electroluminescence) spectrum for blue OLED ITO/PVK∶TPD/LiBq_4/Alq_3/Al device locates at 475 nm,and one weak shoulder peak appears at about 500 nm,this is resulted from excitation of Alq_3.The luminance of this blue OLED can reach 430 cd/m~2 at 25 V operate voltage.As electron transfer material,the thickness of Alq_3 film has distinct influence on the electroluminescence spectra and luminance of blue OLEDs.Through(adjusting) the thickness of Alq_3 layer,the recombination region of holes and electrons can be restricted in LiBq_4,and the shoulder peak will weaken and disappear.The optimal thickness of Alq_3 film is about 10 nm.(Although) the addition of CuPc between ITO and PVK∶TPD could enhance the injection ability of holes,(simultaneously) induces the imbalance injection of charge carriers,and deteriorates the properties of blue OLED.The addition of LiF thin film between Alq_3 and Al cathode could enhance the injection ability of(electrons,) and makes the injection of electrons reach equilibrium with holes.So the recombination probability of holes and electrons was improved and the luminance of blue OLED was improved evidently.These results were explained with the schematic energy level structure of the blue OLEDs.

The Interaction Between Alq3 and LiF

Study of Organic Electrolumenescent Thin Film Cell

Experimental Study of a Chemical Reaction Between LiF and Al

Electronic structure and energy level alignment of Alq3/Al2O3/Al and Alq3/Al interfaces studied by ultraviolet photoemission spectroscopy

Synthesis and Luminescence Properties of Blue Organic Light-emitting Material LiBq4

Chemical Reaction Between Lif And Al With Or Without The Presence Of Alq(3)

Theory of Magnesium/alq3 Interaction in Organic Light Emitting Devices

The enhanced electron injection by fluorinated tris-(8-hydroxy-quinolinato) aluminum derivatives in high efficient Si-anode OLEDs

Thickness Dependent Behavior of Photoluminescence of Tris(8-hydroxyquinoline) Aluminum Film

Investigation of Novel Efficient Electron Injection Lithium Complex Containing Quinoxaline Moiety for Organic Light-Emitting Diodes

Investigation of an efficient YbF3/Al cathode for tris-(8-hydroxyquinoline)aluminum-based small molecular organic light-emitting diodes

Improved Performance of Alq(3)-based Organic Light-Emitting Diode with Multi-Layer Structure

Blocking of interfacial diffusion at Ag/Alq3 by LiF

Study on the Interaction Between Ag and Tris(8-Hydroxyquinoline) Aluminum Using X-Ray Photoelectron Spectroscopy

Achieving blue luminescence of Alq3 through the pull-push effect of the electron-withdrawing and electron-donating substituents

1.54 Mu M Er3+ Electroluminescence from an Erbium-Compound-Doped Organic Light Emitting Diode with A P-Type Silicon Anode

Transparent Organic Light-Emitting Diodes with Lif:Al Composite Cathodes

Light Emission Tuning of Organic Electroluminescence Material of Aluminum Tris-(8-hydroxyquinoline)(Alq_3)

First-principle band structure calculations of tris(8-hydroxyquinolinato)aluminum.

P-113: Novel Structure Organic Light-Emitting Diodes with High Performance

P-113: Society for Information Display: Novel Structure Organic Light-emitting Diodes With High Performance