Abstract:To solve the problems associated with micron-sized aluminum (Al), including sintering, agglomeration, and slag deposition during the combustion of aluminized propellants, aluminum–lithium (Al-Li) alloy, prepared by introducing a small amount of Li (1.0 wt.%) into Al, was used in place of Al. Then, the ignition and combustion characteristics of single micron-sized Al-Li alloy particles were investigated in detail using a self-built experimental apparatus and multiple characterization methods. The ignition probability, ignition delay time, flame propagation rate, burn time, combustion temperature, flame radiation spectra, and microexplosion characteristics were obtained. The TG-DSC results demonstrated that, as compared to the counterpart Al, the Al-Li alloy had a lower ignition temperature. The emission lines of AlO revealed the gas-phase combustion of the Al-Li alloy, and thus the Al-Li alloy exhibited a mixed combustion mode, including surface combustion and gas-phase combustion. Moreover, during combustion, a microexplosion occurred, which increased the combustion rate and reduced the burn lifetime. The ambient pressure had a significant effect on the ignition and combustion characteristics of the Al-Li alloy, and the ignition delay time and burn time exponentially decreased as the ambient pressure enhanced. The combustion temperature of the Al-Li alloy at atmospheric pressure was slightly higher than those at elevated pressures. The Al-Li alloy burned in N2, but no microexplosion was observed. Finally, the ignition and combustion mechanism of the Al-Li alloy in air was demonstrated by combining SEM, EDS, and XRD analyses of the material and residues. The results suggest that the addition of Li promoted the combustion performance of Al by changing the surface structure of the oxide film and the combustion mode.

Experimental Study of a Chemical Reaction Between LiF and Al

Chemical Reaction Between Lif And Al With Or Without The Presence Of Alq(3)

Interfacial Reactions At Al/Lif And Lif/Al

High-resolution Electron-Energy-loss Spectroscopy Study on the Reaction of MgF2 with Alq3(8-hydroxy-quinoline)aluminum

Blocking of interfacial diffusion at Ag/Alq3 by LiF

Formation, Confirmation and Application of Li : Al Alloy As an Electron Injection Layer with Li3N As the Precursor

Experimental Investigation and Thermodynamic Modeling of the Li O–Al O System

Destabilized dehydrogenation reaction of LiBH4 by AlF 3

Anodic Dissolution Behavior of Al-Y Alloy in LiCl-KCl Eutectic and Its Passivation Inhibited Aided by LiF

Electrochemical and quantum chemical studies of the reactions of transition metals M (M = Co, Fe and Ni) with LiF and Li2O

Mechanism of aluminum corrosion in LiFSI-based electrolyte at elevated temperatures

Experimental Researches on Hydrogen Generation by Aluminum with Adding Lithium at High Temperature

Study of the diffusion of Al–Li alloys subjected to an electric field

Leaching performance of Al-bearing spent LiFePO4 cathode powder in H2SO4 aqueous solution

Micro-structure studies of the molten binary K3AlF6–Al2O3 system by in situ high temperature Raman spectroscopy and theoretical simulation

Accurate quantification of lithium in aluminium-lithium alloys with electron energy-loss spectrometry

Hydrogen Production and Temperature Change During the Reaction of Al–Li Alloy with Water Vapor

On the influence of annealing on the compositional and crystallographic properties of sputtered Li-Al-O thin films

Alumina Solubility and Dissolution Rate in NaF-KF-AlF3-LiF-CaF2 Low-Temperature Electrolyte

Electronic structure and energy level alignment of Alq3/Al2O3/Al and Alq3/Al interfaces studied by ultraviolet photoemission spectroscopy

Laser-Induced Ignition and Combustion of Single Micron-Sized Al-Li Alloy Particles in High Pressure Air/N2