Abstract:Positron analysis can reveal the information of atomic level defect of materials like metals or polymers through the study of Doppler broaden 511keV Â¿ spectra of positron with electrons that have different momentum distributions relating with the inner defect of materials. The usually used positrons come from isotope or accelerator positron source that irradiates the materials with positrons from outside. Because of the short range of positron in matter, only the surface of millimeter depth inside metals or polymers could be analyzed. To fulfill the demand of positron analysis inside the materials, high energy X-ray is used to produce positron. Two kinds of reaction is feasible, (1) is positron decay after the (Â¿, n) reaction of high energy photon with low photoneutron threshold nuclide, like N or Fe; (2) is the pair production. We use the first reaction in this paper. The algorithm to analyze the broaden 511keV Â¿ spectra is S factor or FWHM method. Maximum likelihood expectation method is also researched to deconvolute the spectra to remove the detector response for more precise electron momentum information extraction. We setup the facility with 15MeV LINAC and HPGe detector, and then test several specimens including low carbon steel, cast iron, aluminium and copper. The experimental results of five low carbon steel specimens show appreciable correspondence between positron analysis result and tensile elongation. This indicates that the atomic level defect of low carbon steel is within the range of positron analysis. On the other hand, cast iron, aluminium and copper do not show such relation. This is perhaps due to the void in these materials is so much that positron analysis method is saturated.

AN IN-LINE ANALYSIS SYSTEM OF SLOW POSITRON BEAM FOR MOLECULAR BEAM EPITAXY

Design of a Beam-coupling System for a Chip-integrated Spectrometer with a Discrete Linear Waveguide

SIMION Simulation of a Slow Pulsed Positron Beam

The Slow Positron Beam Based on Beijing Electron-Positron Collider

Simulations of slow positron production using a low energy electron accelerator

Investigation of defects of molecular beam epitaxial Si by slow positron beam

Positron analysis based on high energy X-ray source

A New Method of Positron Analysis with Bremsstrahlung-induced X-ray

Simulation of Positron Backscattering and Implantation Profiles Using Geant4 Code

Construction of Molecular Beam Epitaxy and Multi-Probe Scanning Tunneling Potentiometry Combined System

Micro-structure of PECVD Diamond Films by Slow Positron Beam

Space Focusing Simulation for Pulsed Slow Positron Beam by SIMION

Design of a Beam Line for Simultaneous Dual-Beam Ion Implantation

The Study And Investigation Of Inline E-Beam Inspection For 28nm Process Development

Electron Beam Probe: the Analysis of the Electron Beam Spot Expansion and a Prototype Development at IMP

Combinatorial Laser Molecular Beam Epitaxy System Integrated with Specialized Low-temperature Scanning Tunneling Microscopy

Design of fast beam transverse profile monitor in electron storage ring

DESIGN OF A NON-INTERCEPTING BEAM DIAGNOSTIC DEVICE USING NEUTRAL BEAM FLUORESCENCE METHOD

A STUDY OF NO.2 SERIES ZrO2(Y2O3) THIN FILM BY SLOW POSITRONS BEAM

An Electron Optical System for Sheet Beam Vacuum Electron Devices

Investigation Of The Oligo-Scattering Electron Beam In The Air