Abstract:Silicon (Si) wafer is generally used as the substrate for structural analysis and residual stress measurement of thin coatings. A few studies can be found for mechanical and tribological characterization wherein Hertzian contact stress never exceeded 1 GPa. Si, being single crystal, pure, and having low surface roughness (R a ) is an ideal potential candidate for thin coating analysis. However, Si wafer breaks immediately under higher contact stress. The current study aims to push the contact stress limit to test thin coatings on Si wafer especially for friction and wear testing. To serve the purpose, different bias DLC coatings (−120 V, −80 V, −40 V, ZeroV, +40 V, +80 V, +120 V) were deposited on Si wafer employing closed field unbalanced magnetron sputtering (CFUMS) system. Using conveniently available experimental approach, Hertzian contact stress in tribological tests has been pushed up to 2.6 GPa successfully on DLC coated Si wafer. Thus, it is feasible to test thin coatings on Si wafer at high contact stress which will provide useful and consistent friction and wear data such that further test using the steel substrate will be reduced by a significant margin. A thorough mechanical, tribological and structural (Raman) analysis is presented. It was found that −120 V possessed the highest hardness (H: 17.6 GPa), modulus (E: 184 GPa) and residual stress (4.5 GPa). The same coating produced the lowest sp 2 /sp 3 ratio, wear rate using contact stress (0.092 × 10 −13 mm 4 /N) and wear/friction energy (0.071 × 10 −13 mm 3 /J 2 ) in comparison to other coatings used in the study. Counter body analysis for −120 V shows the minimum scratch area depicting friction between transfer film and DLC hence the lowest coefficient of friction (0.061) was obtained. Moreover, surface topography is explained with the aid of atomic force microscope (AFM) images and surface roughness (R a ) data. AFM revealed craters and bumpy like surfaces for positive and negative biased samples respectively.

Stress Measurement At The Interface Between A Si Substrate And Diamond-Like Carbon/Cr/W Films By The Electronic Backscatter Diffraction Method

Study on the Mechanism and Measurement of Stress of Tio2 and Sio2 Thin-Films

Effects of Applying Stress on the Electron Field Emission Properties in Amorphous Carbon Thin Films

Study of Local Stress Using Stress-Absorbing Si Diaphragm

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

Evaluating Interface Effect On Stresses In Thin Films By A Local Curvature Metrology With High Accuracy And Resolution

Comparing Internal Stress in Diamond-Like Carbon Films with Different Structure

The resolution and repeatability of stress measurement by Raman and EBSD in silicon

Ultra-sensitive, Highly Reproducible Film Stress Characterization Using Flexible Suspended Thin Silicon Plates and Local Curvature Measurements

Silicon wafer as a feasible candidate for tribological characterization of thin coatings under high contact stress?

Interface architecture for superthick carbon-based films toward low internal stress and ultrahigh load-bearing capacity

A Microscopic Tem Study Of The Defect Layers In Cast-Mono Crystalline Silicon Wafers Induced By Diamond-Wire Sawing

Effect of stress state in different TiN-films on their tribological performances

FIB-DIC ring-core measurement of the residual stress on HiPIMS W/Cu and Cr/Cu multilayer thin films

Characterizing the Stress and Electrical Properties of Superconducting Molybdenum Films

Residual Stress Measurement and Analysis in Multilayer Film Si- Substrate Structure by Micro-Raman Spectroscopy Technique

X-ray stress measurement of SiC single-crystal induced by laser ablation

Study of stress distribution on nano-polycrystalline silicon thin film with Raman imaging spectrum

Residual Stress Measurement in Thin Films Using a Slitting Method with Geometric Phase Analysis under a Dual Beam (FIB/SEM) System

Internal Stress Measurement of LPCVD Silicon Nitride Deposited on Different Substrates

Microstructure and stress evolution of W nanofilms prepared by arc ion plating under different deposition time and substrate bias