Abstract:In a variable speed drive (VSD) system, high-frequency switching of power devices will cause large common-mode (CM) voltage during operation. While the CM voltage acts on the parasitic capacitance of the system, it will generate serious CM current on the motor side. It is necessary to model the VSD system so as to analyze and forecast the CM current theoretically. However, an essential condition of modeling CM current is to extract the CM impedance on the motor side of the system. In this paper, a novel extraction method for the CM impedance of an inverter-fed induction motor is proposed. First of all, time-domain waveforms of the CM voltage and current on the motor side of the VSD system are measured, and then mathematical calculations are performed to obtain the spectrum characteristics of the CM impedance on the motor side of the system. Compared to the traditional extraction methods of the impedance parameter by an impedance measurement or numerical calculation, the method proposed in this paper does not require laborious modeling of the motor or cable, and the extraction process is much simpler and easier. Moreover, in traditional methods, the motor impedance parameters are usually obtained in a nonworking state, while the proposed extraction method can be conducted in working state. Thus, the CM impedance extracted by the proposed method will be more accurate. Through comparing measurement and the simulation results of the CM current on motor side, the proposed CM impedance extraction method for an inverter-fed induction motor is validated.

Influence of Motor Cable on Common-Mode Currents in an Inverter-Fed Motor Drive System

Modeling of Common-Mode Current in Motor Cable of Inverter-Fed Motor Drive System

Extraction of Common-Mode Impedance of an Inverter-Fed Induction Motor

Estimation of Common-Mode Current Coupled to the Communication Cable in a Motor Drive System

Modeling And Evaluation Of Common-Mode Interference Coupling Effects On Sensitive Cable In Motor Drive System

Effect of Common-Mode Interference on Communication Performance of a Motor Drive System

Modeling of Common-Mode Impedance of an Inverter-Fed Induction Motor from Online Measurement

Influence of Cable Insulation Structure on Terminal Over-Voltage of Inverter-Fed Motor

Modeling of Conducted EMI in Motor Drive System Based on Double Pulse Test and Impedance Measurement

High-Frequency Modeling and Filter Design for PWM Drives with Long Cables

Time-frequency Characteristics Research of Common Mode Current in PWM Motor System

High-frequency Electric-Motor Modelling for Conducted CM Current Prediction in Adjustable Speed Drive System

The Bearing Current Of Inverter-Fed Induction Motors: The Reason And Solution

Analysis and Utilization of Common-mode Voltage in inverters for Power Supply

A study of motor-end EMI filter on output common-mode noise suppression in DC-fed motor drive system

Analysis of EMI in Motor System Driven by PWM Inverter

High-frequency Modelling of Permanent Magnet Synchronous Motor with Star Connection

Comparison of long cable impedances using multiphysics and equivalent circuit models

Experimental Assessment of High Frequency Bearing Currents in an Induction Motor Driven by a SiC Inverter

Predictive Current Control Method To Reduce Common-Mode Interference For Three-Phase Induction Motor

High-frequency modeling based EMC performance improvement of power supplies in inverters