Abstract:Many robotic systems, like surgical robots, robotic hands, and exoskeleton robots, use cable passing through conduits to actuate remote instruments. Cable actuation simplifies the design and allows the actuator to be located at a convenient location, away from the end effector. However, nonlinear frictions between the cable and the conduit account formajor losses in tension transmission across the cable, and a model is needed to characterize their effects in order to analyze and compensate for them. Although some models have been proposed in the literature, they are lumped parameter based and restricted to the very special case of a single cable with constant conduit curvature and constant pretension across the cable only. This paper proposes a mathematically rigorous distributed parameter model for cable-conduit actuation with any curvature and initial tension profile across the cable. The model, which is described by a set of partial differential equations in the continuous time-domain, is also discretized for the effective numerical simulation of the cable motion and tension transmission across the cable. Unlike the existing lumped-parameter-based models, the resultant discretized model enables one to accurately simulate the partial-moving/partial-sticking cable motion of the cable-conduit actuation with any curvature and initial tension profile. The model is further extended to cable-conduit actuation in pull-pull configuration using a pair of cables. Various simulations results are presented to reveal the unique phenomena like backlash, cable slacking, interaction between the two cables, and other nonlinear behaviors associated with the cable conduits in pull-pull configuration. These results are verified by experiments using two dc motors coupled with a cable-conduit pair. The experimental setup has been prepared to emulate a typical cable-actuated robotic system. Experimental results are compared with the simulations and various implications are discussed.

High-Frequency Modeling and Filter Design for PWM Drives with Long Cables

Modeling of Common-Mode Current in Motor Cable of Inverter-Fed Motor Drive System

FEA-Based Mathematical Modeling and Simulation for IPMSM Drive with Consideration of Saturation and Cross-Coupling Influence

Current Control Scheme for LC-Equipped PMSM Drive Considering Decoupling and Resonance Suppression in Synchronous Complex-Vector Frame

Influence of Motor Cable on Common-Mode Currents in an Inverter-Fed Motor Drive System

Comparison of long cable impedances using multiphysics and equivalent circuit models

High-frequency modeling based EMC performance improvement of power supplies in inverters

Design of Over-Voltage Filter at PWM Inverter Output Terminals

Design of filtering cable with defected conductor layer

A New Approach to Mitigate CM and DM Voltage Dv/dt Value in PWM Inverter Drive Motor Systems

Modeling And Evaluation Of Common-Mode Interference Coupling Effects On Sensitive Cable In Motor Drive System

Analysis and Design of Passive Damping for LC-Equipped Permanent-Magnet Synchronous Machine Drive System

Design of Common-Mode and Differential-Mode Voltage dv/dt Filter at PWM Inverter Output Terminals

Influence of Cable Insulation Structure on Terminal Over-Voltage of Inverter-Fed Motor

Modeling and suppression of PWM inverter's adverse effects

Modeling of transmission characteristics across a cable- conduit system

High-frequency Modelling of Permanent Magnet Synchronous Motor with Star Connection

Cable Modeling for Accurate Estimation of Current and Voltage Ripple in Electric Vehicles

Design of a Passive Filter to Reduce Common-Mode and Differential-Mode Voltage Generated by Voltage-Source PWM Inverter

A High Efficient Time-domain Modeling Method for Partial Discharge Propagation in XLPE Cables with Large Length

An Improved Power Cable Insulation Monitoring Method for Inverter-fed Machines Using Switching Oscillation Damping Feature