Abstract:A programmed hybrid spreading spectrum modulation method to mitigate electromagnetic interference (EMI) emission in the context of miniaturised and lightweight synchronous machine drives is proposed. The proposed method is well‐suited for controlling synchronous motors using three‐phase two‐level voltage source inverters. The simulation and experimental results validate the effectiveness of the proposed method, showcasing its advantages in terms of computational complexity reduction and significant attenuation of peak EMI currents. A novel programmed hybrid spreading spectrum modulation method to mitigate electromagnetic interference (EMI) emission and bearing current in the context of miniaturised and lightweight synchronous machine drives is proposed. The proposed method adopts the combination of conventional pulsewidth modulation (PWM) and low common mode voltage PWM. The offline look‐up table for switching frequency is acquired by analysing the root mean square voltage values at different modulation indices and angles. By adjusting the switching frequency according to this table, the spectrum can be spread into the sidebands of the switching frequency, and the harmonic spike can be suppressed. To address the challenge of increased current ripple and harmonic distortion in high torque density motors under overload conditions, a motor model that considers the cross‐saturation and slotting effect is presented. This motor model is used to derive the switching frequency correction factors, aiming to mitigate the influence of saturation and slotting effect on harmonic amplification. The proposed method is well‐suited for controlling synchronous motors using three‐phase two‐level voltage source inverters. The simulation and experimental results validate the effectiveness of the proposed method, showcasing its advantages in terms of computational complexity reduction and significant attenuation of peak EMI currents.

Effect of Common-Mode Interference on Communication Performance of a Motor Drive System

Evaluation of Communication Error Rate Induced by Common-mode Interference of a Motor Drive System

Modeling And Evaluation Of Common-Mode Interference Coupling Effects On Sensitive Cable In Motor Drive System

Modeling of Common-Mode Current in Motor Cable of Inverter-Fed Motor Drive System

Estimation of Common-Mode Current Coupled to the Communication Cable in a Motor Drive System

Influence of Motor Cable on Common-Mode Currents in an Inverter-Fed Motor Drive System

Extraction of Common-Mode Impedance of an Inverter-Fed Induction Motor

Modeling of Common-Mode Impedance of an Inverter-Fed Induction Motor from Online Measurement

Analysis and Suppression of Common Mode Voltage for Motor Drive in EV

Elimination of Common-Mode Choke Saturation Caused by Self-Resonance of the EMI Filter in a Variable-Frequency Drive System

Modeling of Conducted EMI in Motor Drive System Based on Double Pulse Test and Impedance Measurement

Influence of Periodic Carrier Frequency Modulation on Low Frequency Electromagnetic Interference of Permanent Magnet Synchronous Motor Drive System.

Time-frequency Characteristics Research of Common Mode Current in PWM Motor System

Common-Mode Resonance Suppression Strategy in High-Speed Compressor Drive

Analysis and Suppression of Common Mode Voltage for SiC Inverters in Electric Vehicle Applications

Impact of Dead Time Effect on Common Mode Electromagnetic Interference in PMSM Drives

Prediction Model of Conducted Common-Mode EMI in PWM Motor Drive System

Research Status of Conducted Common Mode EMI Restraint Method in PWM Motor Drive System

Analysis of EMI in Motor System Driven by PWM Inverter

Experimental Investigation on Electromagnetic Interference (EMI) in Motor Drive Using Silicon Carbide (SiC) MOSFET

A novel programmed hybrid modulation for electromagnetic interference mitigation and current ripple control in miniaturised synchronous machine drives