Abstract:The silicon carbide (SiC) inverter brings great advantages to the motor drive systems of new energy vehicles; however, severe challenges to the bearings also happen. The high dc bus voltage and switching frequency of SiC inverter can increase the discharge frequency and energy when the bearing grease film collapses. As a result, the bearing suffers severe electric corrosion, and the service life of the motor drive system can be shortened. In this paper, the characteristics of common-mode voltage and bearing voltage are analyzed, firstly under space vector pulse width modulation (SVPWM). After that, the common-mode equivalent circuit model of the motor drive system is established. The frequency characteristics of bearing voltage are revealed, and the safe working area is determined. Then, the frequency characteristics of bearing voltage and current are verified based on IGBT and SiC inverters in experiments. After that, by designing a common-mode filter, the bearing voltage and current are significantly attenuated. Furthermore, the active zero state PWM (AZSPWM) is adopted to reduce the common-mode voltage from the inverter. At the same time, combined with the common-mode filter, the bearing voltage and current are further reduced. The experimental results show that the switching frequency has a decisive effect on the amplitude of bearing voltage and current. The bearing voltage can be attenuated to around half of the reference bearing voltage by using the common-mode filter and AZSPWM strategy, respectively. The combination of the common-mode filter and AZSPWM strategy can reduce the bearing voltage to around one-fourth of the reference bearing voltage, which can effectively reduce the breakdown time and discharge energy of the grease oil film.

Analysis and Suppression of Common Mode Voltage for SiC Inverters in Electric Vehicle Applications

Analysis and Suppression of Common Mode Voltage for Motor Drive in EV

Analysis and Suppression of Shaft Voltage in SiC-Based Inverter for Electric Vehicle Applications

Research on Analysis and Suppression Methods of the Bearing Current for Electric Vehicle Motor Driven by SiC Inverter

Characteristics of SiC inverter powertrains on common-mode EMI noise

Suppression Switching Ringing of SiC-MOSFET Inverters with Combined Design of DC Bus Snubber and Gate Drive

Technical approaches towards ultra-high power density SiC inverter in electric vehicle applications

SiC MOSFETs - the Inevitable Trend for 800V Electric Vehicle Air Conditioning Compressors

Effect of Common-Mode Interference on Communication Performance of a Motor Drive System

Analysis and Utilization of Common-mode Voltage in inverters for Power Supply

Influence of System Layout on CM EMI Noise of SiC Electric Vehicle Powertrains

Analysis for Crosstalk of SiC-MOSFET in a Bridge Circuit and Its Active-Clamped Driver Based Suppression Methods

Analysis and Suppression for Crosstalk in SiC MOSFET Turn-off Transient

Impact of reduced common mode voltage PWM and common mode inductor on EMI characteristics of an inverter-driven motor

Analysis on Static Current Sharing of N-Paralleled Silicon Carbide MOSFETs

Common Mode Voltage Suppression for Three-Level Neutral Point-Clamped Inverters

A Soft-Switching Current-Source-Inverter-Fed Motor Drive With Reduced Common-Mode Voltage

Modeling of Common-Mode Impedance of an Inverter-Fed Induction Motor from Online Measurement

Analysis and Suppression for Gate Oscillation Caused by Body Diodes on Paralleled SiC MOSFETs Application

Time-frequency Characteristics Research of Common Mode Current in PWM Motor System

Analysis and Flexible DV/DT Control of an Active Clamping Topology for Series-Connected SiC MOSFETs