Abstract:In this paper, a high-resistivity silicon (HR-Si) interposer integrated with through-silicon via (TSV) electrically grounded coplanar waveguide (CPW) line is presented for 2.5-D/3-D heterogeneous integration of radio frequency (RF) microelectronics devices. In addition, design of TSV interconnection composed of two coaxial ladder-hollow-annular Cu (copper) TSVs of different diameters is utilized to maintain a sufficient freedom for strict standard cleaning to avoid Si resistivity degradation. The formation of the coaxial ladder TSV structure is more beneficial to the subsequent plating process because it reduces the aspect ratio of TSV vias. Hollow-annular Cu TSV is manufactured in order to reduce the problem of mismatch in coefficient of thermal expansion among TSV's constituent materials. A layer of Au (aurum) film is utilized to passivate the exposed Cu surface of Si interposer. Au is widely used in III-V groups' devices because of the good compatibility with photonic integrated circuits, conductivity, and corrosion resistance. HR-Si interposer with TSV grounded CPW line and test structure is fabricated and characterized. With the monitoring test results, it can be found that it changes little in the resistivity of Si substrate, though the whole process, which is a basic requirement for RF performance. RF property test results show that the insertion loss is about -0.20 dB/mm at 10 GHz for the presented TSV grounded CPW line and -0.02 dB per TSV. These test results are better than the traditional design. To verify its applicability to 2.5-D/3-D heterogeneous integration, RF microelectronics die is assembled on TSV interposer and tested, and the test results prove that it works properly.

Design and Characterization of Petaloid Hollow Cu Interconnection for Interposer

Simulation and Experimental Analysis of Thermomechanical Stress Around Interconnects for W2W Hybrid Bonding

Process Development of A New Tgv Interposer for Wafer Level Package of Inertial Mems Device

Modeling and Characterization of Cu-Graphene Heterogeneous Interconnects

Modeling Simplification for Thermal Mechanical Stress Analysis of TSV Interposer Stack

Fabrication and Characterization of Low Stress Si Interposer with Air-Gapped Si Interconnection for Hermetical System-in-Package

Design, Fabrication and Stress Evaluation of Si Electrical Interconnection Air-gapped from Si Interposer

Interposer Fabrication with Annular Copper Tsv and Multi-Layered Redistribution Layer

Fabrication and Characterization of a Low Parasitic Capacitance and Low-Stress Si Interposer for 2.5-D Integration

Fabrication and Characterization of Annular Copper Through-Silicon Via for Passive Interposer Applications

Interfacial Stress in Through Silicon Vias

Lateral Buckling of Interconnects in A Noncoplanar Mesh Design for Stretchable Electronics

Optimization of Cu protrusion of wafer-to-wafer hybrid bonding for HBM packages application

Experimental and Numerical Studies of Stress Migration in Cu Interconnects Embedded in Different Dielectrics

Fabrication of Microchannel Embedded Tsv Interposer and Its Influence on Tsv'S Electrical Parameters

Layout Dependence Stress Investigation in through Glass via Interposer Architecture Using a Submodeling Simulation Technique and a Factorial Design Approach

Fabrication and RF Property Evaluation of High-Resistivity Si Interposer for 2.5-D/3-D Heterogeneous Integration of RF Devices

Design and fabrication of a TSV interposer for SRAM integration

Process Development of Thick Si Interposer for 2.5d Integration of Rf Mems Devices

Study On Electrical Performance Of Stacking Die Package With Silicon Interposer

Patterned Cu Nanoparticle Film for All-Cu Interconnection Without Chemical Mechanical Polishing Pretreatment