Abstract:A wideband noise-cancelling low-noise amplifier (LNA) without the use of inductors is designed for low-voltage and low-power applications. Based on the common-gate-common-source (CG-CS) topology, a new approach employing local negative feedback is introduced between the parallel CG and CS stages. The moderate gain at the source of the cascode transistor in the CS stage is utilized to boost the transconductance of the CG transistor. This leads to an LNA with higher gain and lower noise figure (NF) compared with the conventional CG-CS LNA, particularly under low power and voltage constraints. By adjusting the local open-loop gain, the NF can be optimized by distributing the power consumption among transistors and resistors based on their contribution to the NF. The optimal value of the local open-loop gain can be obtained by taking into account the effect of phase shift at high frequency. The linearity is improved by employing two types of distortion-cancelling techniques. Fabricated in a 0.13-mu m RF CMOS process, the LNA achieves a voltage gain of 19 dB and an NF of 2.8-3.4 dB over a 3-dB bandwidth of 0.2-3.8 GHz. It consumes 5.7 mA from a 1-V supply and occupies an active area of only 0.025 mm(2).

A Low Power High Gain CMOS LNA with Multiple-Feedback Network for Low Voltage UWB Receiver

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Low Power High Gain UWB LNA in 0.18-Μm CMOS

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

Low Power 0.18&#x00b5;m CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A 0.5-5.6 GHz Inductorless Wideband LNA with Local Active Feedback

A 0.1-10Ghz Ultra-Wideband High-Gain Low-Noise Amplifier for UWB Receiver

A High-Gain Differential Cmos Lna For 3.1-10.6 Ghz Ultra-Wideband Receivers

A High Gain Fully Integrated CMOS LNA for WLAN and Bluetooth Application

Design of Ultra-Wideband LNA with 3.6 ± 0.4 Db NF and 15.9 ± 1.1 Db Gain

The Ultra-Wideband 0.5-15GHz LNA for Reconfigurable Receiver System in 28 nm CMOS

A 2.4 mW, 11.7±0.4dB, 3 to 5 GHz wide-band LNA for super-regenerative IR-UWB receiver

A Fully Integrated LNA for 3-5 GHz UWB Wireless Applications in 0.18-&Amp;#x03bc;m CMOS Technology

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

3–10 GHz, 6.54‐mw CMOS Ultrawideband Low‐noise Amplifier Using a Hybrid Structure

A 3-10 Ghz Uwb Lna Using G(M)-Boosting Structure And Inductive-Peaking-Based Bandwidth Extension Technique In A 180 Nm Cmos Technology

3-10 GHz Ultra-Wideband LNA with Continuously Variable Gain for Wireless Communication

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

A Low Power High Gain CMOS LNA with Multiple-Feedback Network for Low Voltage UWB Receiver

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Low Power High Gain UWB LNA in 0.18-Μm CMOS

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

Low Power 0.18&amp;#x00b5;m CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A 0.5-5.6 GHz Inductorless Wideband LNA with Local Active Feedback

A 0.1-10Ghz Ultra-Wideband High-Gain Low-Noise Amplifier for UWB Receiver

A High-Gain Differential Cmos Lna For 3.1-10.6 Ghz Ultra-Wideband Receivers

A High Gain Fully Integrated CMOS LNA for WLAN and Bluetooth Application

Design of Ultra-Wideband LNA with 3.6 ± 0.4 Db NF and 15.9 ± 1.1 Db Gain

The Ultra-Wideband 0.5-15GHz LNA for Reconfigurable Receiver System in 28 nm CMOS

A 2.4 mW, 11.7±0.4dB, 3 to 5 GHz wide-band LNA for super-regenerative IR-UWB receiver

A Fully Integrated LNA for 3-5 GHz UWB Wireless Applications in 0.18-&Amp;#x03bc;m CMOS Technology

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

3–10 GHz, 6.54‐mw CMOS Ultrawideband Low‐noise Amplifier Using a Hybrid Structure

A 3-10 Ghz Uwb Lna Using G(M)-Boosting Structure And Inductive-Peaking-Based Bandwidth Extension Technique In A 180 Nm Cmos Technology

3-10 GHz Ultra-Wideband LNA with Continuously Variable Gain for Wireless Communication

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver