Abstract:Two single-ended wideband LNAs for ultrawide-band receiver have been designed and implemented in 0.18 /spl mu/m CMOS technology. The first one, a feed-back LNA, is a two-stage amplifier with a improved feedback loop, which provides high gain and enables the input port to match with 50/spl Omega/ in a wide frequency range from 500MHz to 8GHz. The second one, an LC low-pass-filter matched LNA, employs a third-order low pass filter in the input port to match a frequency range from 3GHz to 8GHz. In both of the LNAs, the input stage is a common source amplifier. Inductive shunt peaking is used for maximizing the bandwidth and flatting the gain. In the feed-back LNA, measurements show that the maximum gain is 11.5dB, the 3-dB bandwidth is from 500MHz to 7GHz, 11P3 is -2.2dBm at 4GHz, the minimum noise figure is around 5.7dB, SI 1 is less than -8.2dB, and the power consumption is 14mW. In the LC filter matched LNA, the 3-dB bandwidth is from 3GHz to 7.3GHz. The maximum gain is 9.6dB, IIP3 is 0dBm at 4 GHz, the minimum noise figure is 7.6dB, S11 is less than - 13.4dB and the power consumption is 23mW.

A 2.4 mW, 11.7±0.4dB, 3 to 5 GHz wide-band LNA for super-regenerative IR-UWB receiver

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

Low Power 0.18&#x00b5;m CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A Gm-boosted and current peaking wideband merged LNA and mixer

A 144 GHz 2.5mW multi-stage regenerative receiver for mm-Wave imaging in 65nm CMOS

A 3.8-mW 3.5-4-GHz regenerative FM-UWB receiver with enhanced linearity by utilizing a wideband LNA and dual bandpass filters

0.9–10GHz low noise amplifier with capacitive cross coupling

Broadband CMOS LNAs for IR-UWB Receiver

An Inductor-Less Highly Linear LNA with Noise Cancelling and Current Reusing for 3–5 GHz Low-Power UWB Receivers

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A 0.18 Mu M Cmos Ultra-Wideband Low-Noise Amplifier With High Iip3

A Low Power Interference Robust IR-UWB Transceiver SoC for WBAN Applications

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

A 22-40.5 GHz UWB LNA Design in 0.15um GaAs.

A 2.4 mW, 11.7±0.4dB, 3 to 5 GHz wide-band LNA for super-regenerative IR-UWB receiver

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

3-10 GHz self-biased resistive-feedback lna with inductive source degeneration

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

Low Power 0.18&amp;#x00b5;m CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A Gm-boosted and current peaking wideband merged LNA and mixer

A 144 GHz 2.5mW multi-stage regenerative receiver for mm-Wave imaging in 65nm CMOS

A 3.8-mW 3.5-4-GHz regenerative FM-UWB receiver with enhanced linearity by utilizing a wideband LNA and dual bandpass filters

0.9–10GHz low noise amplifier with capacitive cross coupling

Broadband CMOS LNAs for IR-UWB Receiver

An Inductor-Less Highly Linear LNA with Noise Cancelling and Current Reusing for 3–5 GHz Low-Power UWB Receivers

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A 0.18 Mu M Cmos Ultra-Wideband Low-Noise Amplifier With High Iip3

A Low Power Interference Robust IR-UWB Transceiver SoC for WBAN Applications

A Low Power 3–5 GHz CMOS UWB Receiver Front-End

A 22-40.5 GHz UWB LNA Design in 0.15um GaAs.

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver