Abstract:Two inductorless low-power differential low-noise amplifiers (LNAs) are designed for multiband wireless communication applications. Both LNAs are based on the combination of common-gate (CG) and shunt feedback topologies. In the first LNA, the cross-coupled push-pull structure with separated bias for nMOS and pMOS CG transistors is utilized to realize gm enhancement, partial noise cancellation, and bandwidth extension. In the second LNA, cascode transistors are utilized on the basis of the first topology to alleviate the Miller effect and to construct current steering structures, so as to extend the bandwidth. For both LNAs, in-depth analysis is given, and methods for sizing and biasing optimization under power constraint are proposed to obtain good overall performance tradeoffs while maintaining low-power consumption. The prototypes are implemented in 65-nm low-power CMOS technology. The first LNA achieves a gain of 21.2 dB, a noise figure (NF) of 3-3.5 dB over the 3-dB bandwidth of 200 MHz to 2.7 GHz and an IIP3 of -2 dBm at 1.1 GHz. It consumes 0.96 mW from 1.2-V supply. The second LNA exhibits a gain of 21.2 dB, an NF of 2.8-4 dB over the 3-dB bandwidth of 100 MHz to 4.3 GHz. It consumes 2 mW from 1.2-V supply. Each LNA occupies an area of 0.05 mm(2).

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

0.9–10GHz low noise amplifier with capacitive cross coupling

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

An Inductor-Less Highly Linear LNA with Noise Cancelling and Current Reusing for 3–5 GHz Low-Power UWB Receivers

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

Low Power 0.18&#x00b5;m CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A Single-in-differential-out CMOS RF Front-End for UWB 6&#x2013;9ghz Applications

A 2.4 mW, 11.7±0.4dB, 3 to 5 GHz wide-band LNA for super-regenerative IR-UWB receiver

A 0.0081mm2 0.15–5.9-Ghz Low Noise Amplifier with Noise Cancelling and Current Reuse Techniques

A 2.8–10-GHz CMOS Current Reuse Cascaded Linearity Improving Ultra-Wideband Low-Noise Amplifier

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

1.8-V 3.1-10.6-GHz CMOS low-noise amplifier for ultra-wideband applications

A Power Reduction Technique for Wideband Common Gate Low Noise Amplifers

A novel low-power fully-differential current-reuse cascaded CG-CS-LNA for 6–9-GHz UWB receivers

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

0.9–10GHz low noise amplifier with capacitive cross coupling

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

An Inductor-Less Highly Linear LNA with Noise Cancelling and Current Reusing for 3–5 GHz Low-Power UWB Receivers

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

A Sub-GHz CMOS Low-IF Receiver for Lot Applications

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A fully-integrated low-power 3.1-10.6GHz UWB LNA in 0.18μm CMOS

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

Low Power 0.18&amp;#x00b5;m CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A Single-in-differential-out CMOS RF Front-End for UWB 6&amp;#x2013;9ghz Applications

A 2.4 mW, 11.7±0.4dB, 3 to 5 GHz wide-band LNA for super-regenerative IR-UWB receiver

A 0.0081mm2 0.15–5.9-Ghz Low Noise Amplifier with Noise Cancelling and Current Reuse Techniques

A 2.8–10-GHz CMOS Current Reuse Cascaded Linearity Improving Ultra-Wideband Low-Noise Amplifier

A Wideband Inductorless LNA with Local Feedback and Noise Cancelling for Low-Power Low-Voltage Applications

Wideband Inductorless Low-Power LNAs with Gm Enhancement and Noise-Cancellation.

1.8-V 3.1-10.6-GHz CMOS low-noise amplifier for ultra-wideband applications

A Power Reduction Technique for Wideband Common Gate Low Noise Amplifers

Low Power 0.18µm CMOS Ultra Wideband Inductor-Less LNA Design for UWB Receiver

A Single-in-differential-out CMOS RF Front-End for UWB 6–9ghz Applications