Abstract:The change of mechanical property and microstructure of a main steam pipe made of X20CrMoV12.1 steel for long-term elevated temperature ageing, which has been in service for more than 1.6×105 h under pressure of 13.7 MPa and temperature of 550 °C, was carefully studied so as to evaluate its structural integrity and safety reliability. The tested samples were sectioned from in service elbow. The longitudinal and circumferential mechanical properties of the pipe such as impact strength, tensile strength and hardness were measured respectively at room temperature and elevated temperature of 550 °C. And the change and degradation of the microstructure of the pipe were observed and characterized with the metallurgical method, energy dispersive spectroscope, scanning electron microscope and transmission electron microscope. The experimental results show that the impact property of the pipe was heavily dropped and thus displayed brittle state at normal temperature. Fractography analysis and microstructure characterization further indicate that the pipe is serious in microstructure degradation, obvious in creep damage, severe in inter-granular carbides coursing, and heavy in intralath carbides precipitation. Therefore the structural integrity of the main steam pipe in service was seriously affected, and the on-line inspection and damage class evaluation of the pipe performance should be strengthen.

State Analysis and Life Evaluation on Reformer Furnace Pipe Used for 100000Hrs

State Analysis on the Main Components of Reformer Furnace Pipe Used for A Design Cycle

State analysis on reactor furnace pipe used over a design cycle

Microstructure and Property Analysis of Furnace Pipe Used over a Design Cycle

Experimental and simulative failure analysis of reformer furnace outlet manifolds serviced in aromatic plant

Residual Life Assessment on the Reformer Tube Welded with Serviced and New HP.Nb Material

Corrosion Failures of High Temperature Heat Pipes

Cause Analyses of the Weld Seam Cracks of a Prehydrogenating Reactor

Residual Life Assessment of X20CrMoV12.1 Straight Main Steam Pipe in Service

Endurance Strength and Residual Life Assessment of T23 Steel after 96000 Hours of High Temperature and High Pressure Service

RESIDUE LIFE PREDICTION AND RAPID MAINTENANCE STRATEGIES OF REFORMER FURNACE TUBES

Study on performance degradation of main steam pipe of X20CrMoV12.1 steel for long-term service

Remaining Life Evaluation and Maintenance of Service-Exposed HP-Nb Reformer Tubes

Failure Analysis of High-Temperature Reformer Tube of Incoloy 800H in Synthetic Ammonia Installation

Weldability and Damage Evaluations of Fresh-to-Aged Reformer Furnace Tubes

SIMULATION AND ANALYSIS ABOUT WORN-OUT ON CONNECTING PIPE OF LOW-PRESSURE REHEATER FOR A BOILER OF 600 MW UNIT

BURST ANALYSIS OF HIGH TEMPERATURE RE-HEATER PIPE OF POWERSTATION

Effect of high temperature service on the complex through-wall microstructure of centrifugally cast HP40 reformer tube

Analysis on a Burst High-Temperature-Reheater Pipe in a Power Plant

Cause Analysis and Improvement Measures for Pipeline Cracking of 9Cr-1Mo Material

Evaluating Fitness-for-Service of Corroded Metal Pipelines: Structural Reliability Bases