Abstract:Abstract This study has developed a two-dimensional, two-phase transport model to investigate the transport characteristics in direct methanol fuel cells (DMFCs) using platinum group metal (PGM)-free cathode catalysts. The model considered anisotropic properties of the gas diffusion layer (GDL) caused by current collector’s mechanical compression, the interfacial mass transfer of water and methanol between liquid and vapor, and unique properties of the cathode PGM-free catalyst layer. Results showed that the liquid methanol solution from the anode could provide sufficient water to hydrate the proton exchange membrane (PEM), and the relative humidity of the cathode air did not impact the membrane hydration. Fully hydrating the cathode air may deteriorate the fuel cell performance, especially when the operating temperature is close to 100 °C because the exponential increase of the saturated water pressure with temperature decreased the partial pressure of oxygen. The optimized operating temperature increased with the increase of air pressure and was about 80 °C at 1.5 atm cathode pressure. To achieve the US Department of Energy’s performance target of 300 mW/cm2 peak power density, catalytic activities of both the anode and cathode catalysts need to be improved by one order of magnitude compared with the state-of-the-art commercial catalysts.

Power Generation Experiment of Direct Methanol Fuel Cell

Performance of a Direct Methanol Fuel Cell

The Effect of Methanol Concentration on the Performance of A Passive Dmfc

Effect of Methanol Concentration on Performance of Passive DMFC

Preparation and Simulation of an Additional Catalyst Layer for Direct Methanol Fuel Cell

Design, Optimization and Microfabrication of a Micro-Direct Methanol Fuel Cell with Microblocks in Anode Structure

Design and Fabrication of a Polymer-Based Micro Direct Methanol Fuel Cell

Influence of Current Collector Design and Combination on the Performance of Passive Direct Methanol Fuel Cells

Power characteristics and fluid transfer in 40 W direct methanol fuel cell stack

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

A Methanol Fuel Processing System with Methanol Steam Reforming and CO Selective Methanation Modules for PEMFC Application

Methanol Concentration Control Strategies for Direct Methanol Fuel Cells

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

A Study of the Direct Dimethyl Ether Fuel Cell Using Alkaline Anolyte

Effect of Fabrication and Operating Parameters on Electrochemical Property of Anode and Cathode for Direct Methanol Fuel Cells

A Neat Methanol Fed Passive DMFC with a New Anode Structure

Design and Utilization of a Direct Methanol Fuel Cell

Development of MEMS-based direct methanol fuel cell with high power density using nanoimprint technology

A Liquid–Vapor Two-Phase Model of Direct Methanol Fuel Cells With Platinum Group Metal-Free Cathode Catalyst

An Air-Breathing Micro Direct Methanol Fuel Cell with 3D KOH-Etched Cathode Structure

Performance analysis and multi-optimization of direct methanol fuel cell based on a novel numerical model considering mass transfer