Power characteristics and fluid transfer in 40 W direct methanol fuel cell stack

Yang Liu,Xiaofeng Xie,Yuming Shang,Rong Li,Liang Qi,Jianwei Guo,Virendra K. Mathur
DOI: https://doi.org/10.1016/j.jpowsour.2006.09.017
IF: 9.2
2007-01-01
Journal of Power Sources
Abstract:The methanol crossover, water transfer and power characteristics of a 40W DMFC stack are investigated under various experimental conditions including different methanol concentrations, flow rates at anode and cathode and flow directions of reactant fluids (methanol solution and air). The performance of each cell in a stack shows some non-uniformity especially at higher current densities. Under Z-type flow direction the cells exhibit more uniform behavior than when under U-type flow. The performance of a stack supplied with 1M methanol solution is much better than with 0.5M solution. However, an increased amount of methanol crossover and water transfer across the membrane have been observed. The reactants flow rates at the anode and cathode are found to affect the fluid transfer and cell performance. At a feed of 1M methanol solution and ambient air pressure the maximum power output of the stack is estimated to be about 50W (90mWcm−2). The maximum power density in a stack is about 87% of that of the optimum single cell power before being assembled into a stack.
What problem does this paper attempt to address?