Abstract:To improve the performance of the cell in terms of current density, power density and byproduct water removal from the cathode, three new cathode flow fields are designed, fabricated and tested. Design-1 is a conventional serpentine with a channel width and rib width of 0.8mm . Design-2 is a-four outlet, and one inlet-four zone serpentine with a channel width and rib width of 0.8mm . Design-3 is a four outlet-one inlet four zone serpentine with a gradually reducing channel width from 1.5mm at the inlet to 0.8mm at the four outlets. Design-4 is a four outlet-one inlet four zone zigzag serpentine with a gradually reducing channel width from 1.5mm at the inlet in the middle to 0.8mm at the four outlets. The open angle of 0.16° is used in design-3 and design-4. All the designs cover a 50mm×50mm area with open ratios in the range 48.9% - 50.0% . To assess the cell's performance, an experimental study is conducted to determine the effect of the new cathode flow field design along with methanol flow rates and methanol concentrations. Electrochemical characterization methods are used to measure the power density of the new fabricated transparent DMFC. Results indicate that the highest recorded limiting current density and peak power density by the experiment are 460mA/cm2 and 50mW/cm2 respectively. The reference design using a conventional serpentine flow field attains a current density of 257mA/cm2 and power density of 24mW/cm2 . Comparing new cathode designs with the reference one, the enhancement percentage in terms of the maximum peak power density by design-2, -3 and -4 are 44% , 107% and 22% , respectively. The lower anode flowrates outperforms the higher flowrates. The byproduct water at the cathode was better removed by the new cathode designs compared to the reference design. This research provides leeway for researchers to enhance the performance of DMFCs via new cathode flow fields.

Influence of Current Collector Design and Combination on the Performance of Passive Direct Methanol Fuel Cells

Experimental investigations on the effect of current collector open ratio on the performance of a passive direct methanol fuel cell with liquid electrolyte layer

Novel Anode Electrode Structure with a Fuel Management Layer for High-Concentration Passive Direct Methanol Fuel Cells

Improvement of Direct Methanol Fuel Cell Performance by Modifying Catalyst Coated Membrane Structure

A Neat Methanol Fed Passive DMFC with a New Anode Structure

Effect of Methanol Concentration on Performance of Passive DMFC

Preparation and Simulation of an Additional Catalyst Layer for Direct Methanol Fuel Cell

Enhancing the performance of direct methanol fuel cells using new cathode flow field designs: An experimental investigation

A hybrid cathode catalytic layer composed of M–N–C and Pt/C for direct methanol fuel cells with high methanol tolerance

Influence of intermediate liquid electrolyte layer on the performance of passive direct methanol fuel cell

Effect of Fabrication and Operating Parameters on Electrochemical Property of Anode and Cathode for Direct Methanol Fuel Cells

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

The Effect of Methanol Concentration on the Performance of A Passive Dmfc

Power characteristics and fluid transfer in 40 W direct methanol fuel cell stack

Design, Optimization and Microfabrication of a Micro-Direct Methanol Fuel Cell with Microblocks in Anode Structure

An exploration of the solution of direct methanol fuel cell cost effectiveness

Performance of a Direct Methanol Fuel Cell

Evaluation of structural aspects and operation environments on the performance of passive micro direct methanol fuel cell

Effect of the Microporous Layer Structure and Hydrophobicity on the Performance of Direct Methanol Fuel Cells

A Liquid–Vapor Two-Phase Model of Direct Methanol Fuel Cells With Platinum Group Metal-Free Cathode Catalyst

Recent Progress in Anode Catalysts of Direct Methanol Fuel Cells