Abstract:This research aims at increasing the utilization of platinum-ruthenium alloy (Pt-Ru) catalysts and thus lowering the catalyst loading in anodes for methanol electrooxidation. The direct methanol fuel cell’s (DMFC) anodic catalysts, Pt-Ru/C, were prepared by chemical reduction with a reducing agent added in two kinds of solutions under different circumstances. The reducing agent was added in hot solution with the protection of inert gases or just air, and in cold solution with inert gases. The catalysts were treated at different temperatures. Their performance was tested by cyclic voltammetry and potentiostatic polarization by utilizing their inherent powder microelectrode in 0.5 mol/L CH3OH and 0.5 mol/LH2SO4 solution. The structures and micro-surface images of the catalysts were determined and observed by X-ray diffraction and transmission electron microscopy, respectively. The catalyst prepared in inert gases showed a better catalytic performance for methanol electrooxidation than that prepared in air. It resulted in a more homogeneous distribution of the Pt-Ru alloy in carbon. Its size is small, only about 4.5 nm. The catalytic performance is affected by the order of the reducing agent added. The performance of the catalyst prepared by adding the reductant at constant temperature of the solution is better than that prepared by adding it in the solution at 0°C and then heating it up to the reducing temperature. The structure of the catalyst was modified, and there was an increase in the conversion of ruthenium into the alloyed state and an increase in particle size with the ascension of heat treatment temperature. In addition, the stability of the catalyst was improved after heat treatment.

Performance of a Direct Methanol Fuel Cell

Study on Performance of Liquid-feed Direct Methanol Fuel Cell

Power Generation Experiment of Direct Methanol Fuel Cell

Influence of operation conditions on the performance of single direct methanol fuel cell

Preliminary Study on Direct Ethanol Fuel Cell

Preparation and Influence of Performance of Anodic Catalysts for Direct Methanol Fuel Cell

A high-performance direct methanol fuel cell with a polymer fiber membrane and RuO2/CNTs as a cathode catalyst

Effect of cathode gas flow patterns on performance of micro direct methanol fuel cell

Performance improvement of a micro borohydride fuel cell operating at ambient conditions

The Effect of Methanol Concentration on the Performance of A Passive Dmfc

A Liquid–Vapor Two-Phase Model of Direct Methanol Fuel Cells With Platinum Group Metal-Free Cathode Catalyst

Design and Performance Analysis of an Air-Breathing Micro Direct Methanol Fuel Cell

Performance Research of Direct Dimethyl Ether Fuel Cell

Some Factors Affecting the Performance of Anodic Catalysts for Direct Methanol Fuel Cell

Influence of Current Collector Design and Combination on the Performance of Passive Direct Methanol Fuel Cells

Effect of Methanol Concentration on Performance of Passive DMFC

Performance of alkaline electrolyte-membrane-based direct ethanol fuel cells

Improvement of Direct Methanol Fuel Cell Performance by Modifying Catalyst Coated Membrane Structure

Durability of Direct Internal Reforming of Methanol As Fuel for Solid Oxide Fuel Cell with Double-Sided Cathodes

Effect of flow characteristics and temperature on performance and efficiency of a direct methanol fuel cell stack

Performance Research of a Silicon-Based Micro Direct Methanol Fuel Cell