Abstract:An air-breathing micro direct methanol fuel cell (mu DMFC) with a water collecting and recycling cathode structure is presented in this paper. The mechanism of water generation in cathode and water collection from the cathode is studied. The capillary channels with hydrophilic surface are designed along the ribs of the air-breathing cathode window to collect excessive water. The collected water is then released via an exhaust pipe. Microfabrication techniques, including double-side lithography and KOH etching, are used to fabricate the anode and cathode plates of the mu DMFC on the same silicon wafer simultaneously. The silicon plate surface is treated by low temperature oxygen plasma to improve the hydrophilicity. The mu DMFC with the water collecting and recycling structure and the regular one without, both with an active area of 7.8 x 7.8 mm(2), are assembled and characterized. Experimental results show that the maximum power density and current density of the both mu DMFCs are more than 10 mW cm(-2) and nearly 100 mA cm(-2) at room temperature, respectively. After both mu DMFCs operate at 0.15 V (about 60 mA cm(-2) at room temperature) for 1 h, the outputs of the prototype with water collecting and recycling structure decrease to about 9.7 mW cm(-2) and 95 mA cm(-2) only, while that of regular one decrease to 9 mW cm(-2) and 75 mA cm(-2). The water is collected by the exhaust pipe in evidence. As such, it would be possible to recycle the water from cathode to anode. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Design and fabrication of a silicon-based micro direct methanol fuel cell stack

A micro-direct methanol fuel cell stack with optimized design and microfabrication

A Silicon-Based Micro Direct Methanol Fuel Cell Stack with Compact Structure and PDMS Packaging

An Air-Breathing Micro Direct Methanol Fuel Cell Stack Employing a Single Shared Anode Using Silicon Microfabrication Technologies

Design, Optimization and Microfabrication of a Micro-Direct Methanol Fuel Cell with Microblocks in Anode Structure

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

A Silicon-Based Micro Direct Methanol Fuel Cell with Microblocks in Anode Structure

Design and Fabrication of a Polymer-Based Micro Direct Methanol Fuel Cell

Miniaturized silicon-based direct methanol fuel cell

Microfluidic fuel cells integrating slanted groove micro-mixers to terminate growth of depletion boundary layer thickness

A Micro Direct Methanol Fuel Cell Using PDMS Assembly Technology

A Monolithic Integrated Micro Direct Methanol Fuel Cell Based on Sulfo Functionalized Porous Silicon

Experimental Study on High-Efficiency Microtubular Solid Oxide Fuel Cell Stacks Using Various Fuels

An Air-Breathing Micro Direct Methanol Fuel Cell with 3D KOH-Etched Cathode Structure

A Novel Assembly Method for a Micro Direct Methanol Fuel Cell Using Multi-Layer Bonding Technique

A fully capillary-driven μDMFC twin-stack operating in all orientations

A Water Collecting and Recycling Structure for Silicon-Based Micro Direct Methanol Fuel Cells

Development of Integrated Packaged Single Fuel Cell Short Stack Based on Titanium Metal Plates for Mobile Power Generation

Passive Fuel Delivery Based on Hydrophobic Porous Silicon for Micro Direct Methanol Fuel Cells

A Fully Capillary-Driven Mu Dmfc Twin-Stack Operating In All Orientations

Power characteristics and fluid transfer in 40 W direct methanol fuel cell stack