Abstract:An air-breathing micro direct methanol fuel cell (mu DMFC) with a water collecting and recycling cathode structure is presented in this paper. The mechanism of water generation in cathode and water collection from the cathode is studied. The capillary channels with hydrophilic surface are designed along the ribs of the air-breathing cathode window to collect excessive water. The collected water is then released via an exhaust pipe. Microfabrication techniques, including double-side lithography and KOH etching, are used to fabricate the anode and cathode plates of the mu DMFC on the same silicon wafer simultaneously. The silicon plate surface is treated by low temperature oxygen plasma to improve the hydrophilicity. The mu DMFC with the water collecting and recycling structure and the regular one without, both with an active area of 7.8 x 7.8 mm(2), are assembled and characterized. Experimental results show that the maximum power density and current density of the both mu DMFCs are more than 10 mW cm(-2) and nearly 100 mA cm(-2) at room temperature, respectively. After both mu DMFCs operate at 0.15 V (about 60 mA cm(-2) at room temperature) for 1 h, the outputs of the prototype with water collecting and recycling structure decrease to about 9.7 mW cm(-2) and 95 mA cm(-2) only, while that of regular one decrease to 9 mW cm(-2) and 75 mA cm(-2). The water is collected by the exhaust pipe in evidence. As such, it would be possible to recycle the water from cathode to anode. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.

Passive Fuel Delivery Based on Hydrophobic Porous Silicon for Micro Direct Methanol Fuel Cells

A Passive Vapor-Feed Direct Methanol Fuel Cell Based on a Composite Pervaporation Membrane

Microfluidic fuel cells integrating slanted groove micro-mixers to terminate growth of depletion boundary layer thickness

A Monolithic Integrated Micro Direct Methanol Fuel Cell Based on Sulfo Functionalized Porous Silicon

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

Design and Fabrication of Fuel-Self-Propelled Reaction Device for Passive Micro Direct Methanol Fuel Cell Anodes

Nano porous silicon membrane with channels for micro direct methanol fuel cells

A Micro Direct Methanol Fuel Cell Using PDMS Assembly Technology

A Neat Methanol Fed Passive DMFC with a New Anode Structure

A Water Collecting and Recycling Structure for Silicon-Based Micro Direct Methanol Fuel Cells

Design and fabrication of a silicon-based micro direct methanol fuel cell stack

Miniaturized silicon-based direct methanol fuel cell

A Methanol Fuel Processing System with Methanol Steam Reforming and CO Selective Methanation Modules for PEMFC Application

Design and Fabrication of a Polymer-Based Micro Direct Methanol Fuel Cell

A Silicon-Based Micro Direct Methanol Fuel Cell with Microblocks in Anode Structure

Numerical simulation on mass transport in a passive vapor-fed direct methanol fuel cell operating with neat methanol

A Novel Proton Exchange Membrane Based on Sulfo Functionalized Porous Silicon for Monolithic Integrated Micro Direct Methanol Fuel Cells

A fully capillary-driven μDMFC twin-stack operating in all orientations

An Air-Breathing Micro Direct Methanol Fuel Cell Stack Employing a Single Shared Anode Using Silicon Microfabrication Technologies

Mechanically Robust and Highly Methanol-Resistant Sulfonated Poly(ether Ether Ketone)/poly(vinylidene Fluoride) Nanofiber Composite Membranes for Direct Methanol Fuel Cells

Capillary-based Water Removal Cathode for an Air-Breathing Micro Direct Methanol Fuel Cell