Development of MEMS-based direct methanol fuel cell with high power density using nanoimprint technology

Yi Zhang,Jian Lu,Satoshi Shimano,Haoshen Zhou,Ryutaro Maeda
DOI: https://doi.org/10.1016/j.elecom.2007.01.051
IF: 5.443
2007-01-01
Electrochemistry Communications
Abstract:Performance of MEMS-based DMFC is low, because graphite-based porous electrodes show poor compatibility with MEMS technology. Nanoimprint technology was adopted in this paper to prepare fine pattern on proton exchange membrane (PEM) in MEMS-based DMFC as a promising alternative to the graphite-based porous electrodes. Micro-convex with the diameter of about 600nm and the height of 50–70nm was prepared on Nafion® 117 membrane by the nanoimprint at 130°C using silicon mold. Thick Pt film (20nm) was deposited as catalyst directly on the nanoimprinted Nafion® 117 membrane. Then the Pt-coated PEM was sandwiched with micro-channeled silicon plates to form a micro-DMFC. With passively feeding of 1M methanol solution and air at room temperature, the as-prepared cell had the open circuit voltage (OCV) of 0.74V and the maximum power density of 0.20mW/cm2. The measured OCV was higher than those (0.1–0.3V) of the state-of-the-art MEMS-based DMFC with planar electrode and pure Pt catalyst.
What problem does this paper attempt to address?