Abstract:Heat integration and process optimization for the hydrogen production units of 1kW low-temperature proton exchange membrane fuel cells (LT-PEMFCs) were studied. Hydrogen is produced from methane in a process consisting of a steam methane reforming reaction (SMR), a high-temperature water–gas shift reaction (HWGS), a low-temperature water–gas shift reaction (LWGS), and a preferential oxidation reaction (PROX). Using commercial Aspen Plus® software, the process was designed and simulated with the objective of energy recovery. Furthermore, the unit operation parameters were discussed based on the mass/heat balances. Pinch analysis was applied for heat integration and process optimization to improve the energy recovery level of the hydrogen production system. By integrating system heating, a maximum energy recovery network (MER) and also a relaxed network were developed. The efficiencies of the hydrogen production systems designed with these MER and relaxed networks were 84.3% and 80.1%, respectively. Compared with the MER design, the relaxed network greatly simplifies the hydrogen production process and reduces the exchanger number from 18 to 9. The penalty in terms of power for relaxation is 120W. Sensitivity analysis shows that heat loss and the steam-to-carbon (S/C) ratio are the primary factors influencing the system efficiency, i.e., a 5% heat loss may result in a 7% efficiency drop, and increasing the S/C ratio from 2.5 to 3.0 may result in a 2.5% efficiency drop. The conversion of methane (XCH4) and the relative deviation from chemical equilibrium for the WGS reactions (both HWGS and LWGS) are secondary factors: efficiency drops 3.5% at XCH4=0.8 and at 0.9 of the WGS equilibrium, compared with equilibrium conditions. Finally, the minimum pinch temperature difference (ΔTmin) and reaction temperatures have little impact on system efficiency. Therefore, the device insulation and catalyst performance are very important for system performance.

Development of Integrated Thermally Autonomous Reformed Methanol-Proton Exchange Membrane Fuel Cell System

Development of Highly Efficient Methanol Steam Reforming System for Hydrogen Production and Supply for a Low Temperature Proton Exchange Membrane Fuel Cell

A Methanol Fuel Processing System with Methanol Steam Reforming and CO Selective Methanation Modules for PEMFC Application

Design, Fabrication and Performance Evaluation of an Integrated Reformed Methanol Fuel Cell for Portable Use

Coupling of high-temperature proton exchange membrane fuel cells with methanol steam reforming: Modeling and simulation for an integrated coupled for power generation system

A review of reformed methanol-high temperature proton exchange membrane fuel cell systems

Techno-economic Assessment and Multi-Objective Optimization of a Hybrid Methanol-Reforming Proton Exchange Membrane Fuel Cell System with Cascading Energy Utilization

High Temperature Polymer Electrolyte Membrane Fuel Cells for Integrated Fuel Cell – Methanol Reformer Power Systems: A Critical Review

Analysis of a hybrid system combining solar-assisted methanol reforming and fuel cell power generation

A Micro-Reactor with Micro-Pin-fin Arrays for Hydrogen Production Via Methanol Steam Reforming

Design and operation optimization of an on-site hydrogen production and purification integration system for PEMFC

Bench-scale Methanol Autothermal Reformer for Distributed Hydrogen Production

The Design and Development of a PEMFC Testing System

Optimum Design and Performance Simulation of a Multi-Device Integrated System Based on a Proton Exchange Membrane Fuel Cell

Development of Pure Hydrogen Generation System Based on Methanol Steam Reforming and Pd Membrane

Modeling of Packed Bed Methanol Steam Reformer Integrated with Tubular High Temperature Proton Exchange Membrane Fuel Cell

Performance, Efficiency, and Flexibility Analysis of a High-Temperature Proton Exchange Membrane Fuel Cell-Based Micro-Combined Heat-and-Power System with Intensification of the Steam Methane Reforming Step by Using a Millistructured Reactor

Carbone-neutral oriented methanol-reforming HT-PEMFC cogeneration based on absorption power refrigeration cycle

Heat Integration and Optimization of Hydrogen Production for a 1 Kw Low-Temperature Proton Exchange Membrane Fuel Cell

Development of 130 Kw Self-Humidifying Proton Exchange Membrane Fuel Cell System

Integration of high temperature PEM fuel cells with a methanol reformer