Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

Comparisons of the Straight Torsion Beam and Folded Torsion Beam Designs for MEMS Micromirrors

An Improved Design Method of the MEMS-Based Folded-Beam Micromirror

Comparative Study of the Beam Steering by a Single Layer of Dielectric and Magnetic Cylinders

Electromechanical Studies On Micro Torsion-Mirror Actuators With Monolithically Integrated Fiber Self-Holding Structures

Design of an Electrostatic Silicon Torsion Micromirror for Low Drive Voltage and Wide Angle MEMS Optical Switch Applications

Design, Fabrication and Characterization of Novel Micromirror with Vertical Torsion Comb Driver

Simulation, Optimization and Measurement of MEMS Torsion Micro Mirrors for Optical MEMS Application

A study of dynamic characteristics and simulation of MEMS torsional micromirrors

Novel MEMS Torsional Mirror Optical Switch

A Novel Electrostatically Driven Micromirror with Lateral Comb Actuators and T-Shaped Torsion Bars

Theoretical modeling and experimental investigation of in-phase resonant MEMS mirrors with cascaded structures

Reduced-Order Modelling of the Bending of an Array of Torsional Micromirrors

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Design, modeling and experimental validation of a micro cantilever beam with an electro-controllable twisting ability

The Improvement of the Micro Torsional Mirror by a Reinforced Folded Frame

Structural Model of Electrostatically Actuated Micromechanical Component

Novel Optical Torsion-Mirror Components For Fiber Sensing Or Networking Applications

Fabrication of the Open-Loop MEMS-Based Tilting Mirror Using the Compound Process

Mechanical Behaviors Research and the Structural Design of a Bipolar Electrostatic Actuation Microbeam Resonator

A Novel Type Of Vertical Torsion Micro-Mirror With Combs

Experimental Investigation of Vibration Isolator for Large Aperture Electromagnetic MEMS Micromirror