Abstract:The micro-electro-mechanical system (MEMS) resonator developed based on surface processing technology usually changes the section shape either due to excessive etching or insufficient etching. In this paper, a section parameter is proposed to describe the microbeam changes in the upper and lower sections. The effect of section change on the mechanical properties is studied analytically and verified through numerical and finite element solutions. A doubly-clamped microbeam-based resonator, which is actuated by an electrode on one side, is investigated. The higher-order model is derived without neglecting the effects of neutral plane stretching and electrostatic nonlinearity. Further, the Galerkin method and Newton⁻Cotes method are used to reduce the complexity and order of the derived model. First of all, the influence of microbeam shape and gap variation on the static pull-in are studied. Then, the dynamic analysis of the system is investigated. The method of multiple scales (MMS) is applied to determine the response of the system for small amplitude vibrations. The relationship between the microbeam shape and the frequency response is discussed. Results show that the change of section and gap distance can make the vibration soften, harden, and so on. Furthermore, when the amplitude of vibration is large, the frequency response softening effect is weakened by the MMS. If the nonlinearity shows hardening-type behavior at the beginning, with the increase of the amplitude, the frequency response will shift from hardening to softening behavior. The large amplitude in-well motions are studied to investigate the transitions between hardening and softening behaviors. Finally, the finite element analysis using COMSOL software (COMSOL Inc., Stockholm, Sweden) is carried out to verify the theoretical results, and the two results are very close to each other in the stable region.

Structural Model of Electrostatically Actuated Micromechanical Component

Analytical model of electrostatic fixed-fixed microbeam for pull-in voltage

Macromodeling of the electrostatically actuated circular plate based on mode superposition method

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

Macro modeling method for electrostatic-drive silicon diaphragm

Electromechanical Analysis and Simplified Modeling of Dielectric Elastomer Multilayer Bending Actuator

Dynamic Characteristics of Electrostatically Actuated Shape Optimized Variable Geometry Microbeam

Static and Dynamic Mechanical Behaviors of Electrostatic MEMS Resonator with Surface Processing Error

Coupled-field finite element analysis of MEMS compound electrostatic actuator by using the ANSYS software

Mechanical Behaviors Research and the Structural Design of a Bipolar Electrostatic Actuation Microbeam Resonator

RESEARCH ON COUPLED ELECTRO-MECHANICAL ANALYSIS AND APPLICATION FOR TYPICAL COMPONENTS IN MEMS

Multiflexoelectric Actuation and Control of Beams

Coulomb-actuated microbeams revisited: experimental and numerical modal decomposition of the saddle-node bifurcation

Theoretical Modeling of Microscopic Photothermal Expansion and Experimental Study of Photothermal Microactuators

Structural Design and Testing of a Micromechanical Resonant Accelerometer

Study of New Photothermal Microactuator Based on Micro/nano Scale Photothermal Expansion

Fabrication and Fatigue Testing of an Electrostatically Driven Microcantilever Beam

Modeling of a micropump membrane with electrostatic actuator

Electromechanical analysis of a self-sensing torsional micro-actuator based on CNTs reinforced piezoelectric composite with damage

Dynamic Characteristics of Electrostatically Actuated Microbeams with Slant Crack

Modeling the Electrostatic Deflection of a MEMS Multilayers Based Actuator