Abstract:β‐Si3N4 ceramics with an additive oxide system of 1 wt% MgO and 3 wt% Re2O3 (Re = Gd, La, Y and Yb) were fabricated by liquid phase sintering at 1950°C under nitrogen pressure of 748 kPa. Starting α‐Si3N4 powder with 10 vol% rod‐like β‐Si3N4 seed crystallites and an extended sintering time from 5 to 40 h resulted in the formation of bimodal microstructure composed of fine matrix grains and large grains. The 40 h‐sintered specimens of pseudo ternary β‐Si3N4‐MgO‐Gd2O3 system exhibited enhanced thermal conductivity of 127.2 ± 2.5 W m−1 K−1 associated with a degradation of the fracture strength from 1008.0 ± 38.0 to 491.7 ± 32.0 MPa, which was due to the formation of coarse‐grained aggregates that acted as both fracture origin as well as a thermal conductive pathway. The theoretical thermal conductivity was predicted for the sintered specimens by using equations based on a mean‐field micromechanics model to estimate the effective thermal conductivity of each component of binary composites. The calculation results suggested that the thermal conductivity of the large β‐Si3N4 grains (≥ 2 μm in diameter) was relatively high and estimated to be in the range of 175 to 191 Wm−1 K−1.The improved thermal conductivity of the 40 h‐sintered specimens was further discussed for the series of β‐Si3N4‐MgO‐Re2O3 systems based on the nanostructure characterization results obtained by the high‐resolution transmission electron microscopy and scanning transmission electron microscopy‐energy dispersive X‐ray spectrometry analyses. This article is protected by copyright. All rights reserved

Fabrication of Spherical Thermal-Conductive Silicon Nitride Powder

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Sintering of beta-Si3N4 Powder and Thermal Conductivity of the Ceramic

Sintering of β-Si_3N_4 Powder and Thermal Conductivity of the Ceramic

Effect of β-Si<sub>3</sub>N<sub>4</sub> Powder on Thermal Conductivity of Silicon Nitride Ceramics

Synthesis of Spherical Si3N4 Powders by Liquid‐phase Modified Carbothermal Reduction and Nitridation

Study on Thermal Conductivity of Spark-Plasma-Sintered Silicon Nitride Ceramics

Microstructure Tailoring of High Thermal Conductive Silicon Nitride Through Addition of Nuclei with Spark Plasma Sintering and Post-Sintering Heat Treatment

Effect Of Microstructural Modification On Thermal Conductivity And Strength Of Silicon Nitride

Fabrication of high thermal conductivity silicon nitride ceramics by pressureless sintering with MgO and Y2O3 as sintering additives

Precisely Controlled Carbothermal Synthesis of Spherical Β-Si3n4 Granules

Pressureless Sintering and Properties Investigation of Silicon Nitride

An investigation on the thermal and microstructural properties of low-cost pressureless sintered silicon nitride (Si3N4) ceramics incorporated with Y2O3-SiO2-MgO

Thermal conductivity improvement in Si3N4 ceramics via grain purification

Fabrication of Fine-Grained Si 3 N 4 -Si 2 N 2 O Composites by Sintering Amorphous Nano-Sized Silicon Nitride Powders

Synthesis of monodisperse and high-purity α-Si3N4 powder by carbothermal reduction and nitridation

Effect of CeO2, Dy2O3, Yb 2O3 and y2O3 additives on thermal conductivity of silicon nitride ceramics

Effects of MgSiN2 Addition and Post-Annealing on Mechanical and Thermal Properties of Si3N4 Ceramics

Study on Thermal Conductivity of Si3N4 Sintered with Y2O3-MgO Additive System

Influence of Stabilizing Ions and Sintering Process on the Thermal Conductivity of Α‐sialon Ceramics