Abstract:Introduction Laser peen forming (LPF) is a forming technique using laser-induced plasma to impact the workpiece spot-by-spot and forming the metal sheet into a specified curvature. It is a complex physics process including laser ablation, shock wave propagation, material yielding and deformation accumulation. A high-intensity short-pulsed laser irradiates on the surface of the workpiece, as a result, high pressure plasma generates on the surface of the workpiece in the confinement of water. In the impact of high pressure plasma, the shock pressure generates and spreads to the depth direction. The amplitude of the shock wave arrives at 1-10 GPa and the time duration is around 100 nanoseconds, as a consequence LPF is a high-dynamic response process due to the laser shock process. When the shock wave exceeds the Von Mises stress of materials, the workpiece in the shock zone yields and generates plastic strain. After laser scanning over the workpiece surface, the deformation is accumulated with the expanding of the plastic zone, resulting in the workpiece bending into a small curvature convex shape. In order to overcome the difficulty of improving the pulse energy, laser-assisted laser peen forming(LALPF) was proposed by Hu et al. [1] to improve the bending capability. LALPF adapted CW laser heating to increase the deformation. Laser heating plays an assisted role in softening the material and altering the stress state of material during LALPF. Simutationly, the back surface of the workpiece is heating by continuous wave (CW) laser which is coaxial with the pulsed laser. The material absorbs the CW laser energy resulting in high temperature field in the local area. The local high temperature decreases the yield strength, inducing thermal stress even plastic thermal strain owing to the nonuniform expansion of material. Thus, lager and deeper plastic strain is generated in the laser shock process and the deformation of the workpiece increase compared with the LPF in room temperature.

Numerical and experimental study on bi-direction deformations in laser micro forming of two-bridge actuators

Study on the Mechanical Behavior of Laser Micro-Adjustment of Two-Bridge Actuators

The Interactive Effects on Deformation Behavior in Laser Thermal Adjustment of Two-Bridge Actuators

Numerical Investigation of Dual Heating in Laser Micro-Adjustment of Actuators

Analysis and Prediction of the In-Plane Deformation in Laser Thermal Adjustment

The Process Planning in Laser Thermal Adjustment of Three Cut-Outs Actuators

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Numerical Study on Deformation Behaviors in Intersecting Rectilinear Laser Bending

Mechanism of Laser Micro-Adjustment

NUMERICAL INVESTIGATION OF STRAIGHT-LINE LASER FORMING UNDER THE TEMPERATURE GRADIENT MECHANISM

Research on the Mechanisms of Laser Forming for the Micro-Structural Element

Numerical Simulation of the Laser Forming of Plates Using Two Simultaneous Scans

Processing Optimization in Multiheating Positions for Laser Thermal Adjustment of Actuators

Analysis and Experimentation of Novel Bi-Directional Photo-Thermal Micro-Actuators

On the competition between in-plane and out-of-plane deformations in laser thermal adjustment

Numerical Modeling and Mechanism Analysis of Hybrid Heating and Shock Process for Laser-Assisted Laser Peen Forming

Numerical Simulation Research on Laser Shock Forming

Numerical modelling of deformation prediction for laser-assisted laser peen forming

The Effect of Infrared Laser-Induced Micro/Nano Photothermal Expansion and the Novel Method of Photothermal Actuation

Three-dimensional numerical simulation and experimental study of sheet metal bending by laser peen forming

Research on the mechanisms of laser forming for the metal plate