Abstract:This paper describes a precise and non-contact adjustment technique using the water-confined laser-generated plasma to adjust the curvature of micro-components (micro-mechanical cantilevers). A series of laser shock micro-adjustment experiments were conducted on 0.4mm-thick Al samples using pulsed Nd:YAG lasers operating at 1064nm wavelengths to verify the technical feasibility. Systematic study was carried out in the term of effects of various factors on the adjusting results, including laser energies, laser focus positions, laser shock times and confined regime configuration. The research results have shown that the different bending angles and bending directions can be obtained by changing the laser processing parameters. And, for the adjustment process, the absence of confined regime configuration could also generate suitable bending deformation. But, in the case of larger energy, the final surfaces would have the sign of ablation, hence resulting in poor surface quality. An analysis procedure including dynamic analysis performed by ANSYS/LS-DYNA and static analysis performed by ANSYS is presented in detail to attain the simulation of laser shock micro-adjustment to predict the final bending deformation. The predicted bending profiles is well correlated with the available experimental data, showing the finite element analysis can predict the final curvatures of the micro-cantilevers properly.

Mechanism of Laser Micro-Adjustment

Study on the Mechanical Behavior of Laser Micro-Adjustment of Two-Bridge Actuators

Analysis and Prediction of the In-Plane Deformation in Laser Thermal Adjustment

Research on the Mechanisms of Laser Forming for the Micro-Structural Element

Numerical and experimental study on bi-direction deformations in laser micro forming of two-bridge actuators

Processing Optimization in Multiheating Positions for Laser Thermal Adjustment of Actuators

Research on the mechanisms of laser forming for the metal plate

Numerical Investigation of Dual Heating in Laser Micro-Adjustment of Actuators

Photothermal Microactuator Manufactured by Excimer Laser

The Effect of Infrared Laser-Induced Micro/Nano Photothermal Expansion and the Novel Method of Photothermal Actuation

Numerical Modeling and Mechanism Analysis of Hybrid Heating and Shock Process for Laser-Assisted Laser Peen Forming

The Process Planning in Laser Thermal Adjustment of Three Cut-Outs Actuators

An Accurate Thermomechanical Model for Laser-Driven Microtransfer Printing

On the competition between in-plane and out-of-plane deformations in laser thermal adjustment

Theoretical Modelling and Experimental Study of Novel Photothermal Microactuators

Theoretical Modeling of Microscopic Photothermal Expansion and Experimental Study of Photothermal Microactuators

The Interactive Effects on Deformation Behavior in Laser Thermal Adjustment of Two-Bridge Actuators

Laser-Driven Micro Transfer Placement of Prefabricated Microstructures

Analysis and experimentation of novel asymmetric photo-thermal micro-actuator

Dynamic characteristics of micro-optothermal expansion and optothermal microactuators

Numerical Simulation and Experimentation of Adjusting the Curvatures of Micro-Cantilevers Using the Water-Confined Laser-Generated Plasma