Abstract:The objective of this work is a dilatometric study of Al + 0.1% of multiwall carbon nanotubes nanocomposite material (NCM) in three directions: X - parallel to the rolling direction; Y - perpendicular to the rolling direction and (Z) perpendicular to the ribbon plane. NCM specimens were made in the form of a 0.1-mm-thick ribbon. The temperature range used for measurements was 20°C to 600°C. The obtained results show that presence of nanotubes affects the thermal expansion coefficient (TEC) measured in different directions. αx(T) and αy(T) - TEC plots as a function of temperature along X and Y directions, respectively - have substantially the same shape and overlap in the area of 400°C. The expansion along X-axis becomes greater than along Y-axis below this temperature value. It is clear that the coefficient αz(T) is lower than αx(T) and αy(T) over the entire temperature range. The expansion along Z-axis is smaller compared to that along X- and Y-axes. This behaviour suggests that there is a strong interatomic interaction along this direction (Z). αz(T) becomes monotonous and constant and is equal to 8 × 10(-6)°C(-1) at temperatures above 300°C. Such order of magnitude had not been obtained in earlier studies of aluminium alloys. The obtained TEC shows high anisotropy, which grows with the increase of temperature. The heat flow (differential scanning calorimetry, (DSC)) of Al + 0.1% carbon nanotubes (CNT) NCM is more intense compared to that of pure aluminium produced in similar conditions. The two representative curves have similar shape and are almost entirely overlapped. The thermogravimetry results confirm those of DSC. The Raman spectrum of this nanomaterial shows that intensity of G and D bonds is significantly increased compared to that of the pure material. The infrared diagram also confirms that in this case the mentioned bonds are more intensive NCM. The tensile strength measurements (σB) of the studied NCM also demonstrate that its value increases from 140 ± 10 MPa for Al without nanotubes to 200 ± 10 MPa for NCM.

Thermal Performance of Vertically-Aligned Multi-Walled Carbon Nanotube Array Grown on Platinum Film

Thermal Conductivity of A New Carbon Nanotube Analog: the Diamond Nanothread

Thermal Conductivity Of Configurable Two-Dimensional Carbon Nanotube Architecture And Strain Modulation

Thermal diffusivity and conductivity of multiwalled carbon nanotube arrays

Mechanical and Thermal Properties of Graphyne-Coated Carbon Nanotubes: a Molecular Dynamics Simulation on One-Dimensional All-Carbon Van Der Waals Heterostructures

Thermal Properties of Carbon Nanotube Array Used for Integrated Circuit Cooling

Crack-free and Scalable Transfer of Carbon Nanotube Arrays into Flexible and Highly Thermal Conductive Composite Film.

Thermal Conduction in Vertically Aligned Copper Nanowire Arrays and Composites

Thermal Management for Purification of Aligned Arrays of Single-Walled Carbon Nanotubes Based on Thermocapillary Flow by Pulsed Heating

Effect of Contact Pressure on the Performance of Carbon Nanotube Arrays Thermal Interface Material

Thermal Transport in One-Dimensional Van Der Waals Heterostructures: Effects of Coating Layers on the Thermal Conductivity of Carbon Nanotubes

Characterize the Thermal Properties of the Vertical Aligned Carbon Nanotubes Array Used for IC Cooling with Photothermal Method

The Effects of Morphology and Temperature on the Tensile Characteristics of Carbon Nitride Nanothreads.

High-Quality Vertically Aligned Carbon Nanotubes for Applications as Thermal Interface Materials

Thermal resistance of thermal conductive adhesive anchored carbon nanotubes interface material

Differential Multi-probe Thermal Transport Measurements of Multi-walled Carbon Nanotubes grown by Chemical Vapor Deposition

Nanoscale Heat Transport of Vertically Aligned Carbon Nanotube Bundles for Thermal Management Applications

Synthesis of high quality, closely packed vertically aligned carbon nanotube array and a quantitative study of the influence of packing density on the collective thermal conductivity

Effects of Surface Metal Layer on the Thermal Contact Resistance of Carbon Nanotube Arrays

Thermal analysis of Al + 0.1% CNT ribbon

Improved thermal conductivities of vertically aligned carbon nanotube arrays using three-dimensional carbon nanotube networks