Abstract:With the increase in power consumption in compact electronic devices, passive heat transfer cooling technologies with high-heat-flux characteristics are highly desired in microelectronic industries. Carbon nanotube (CNT) clusters have high thermal conductivity, nanopore size, and large porosity and can be used as wick structure in a heat pipe heatspreader to provide high capillary force for high-heat-flux thermal management. This paper reports investigations of high-heat-flux cooling of the CNT biwick structure, associated with the development of a reliable thermometer and high performance heater. The thermometer/heater is a 100-nm-thick and 600 μm wide Z-shaped platinum wire resistor, fabricated on a thermally oxidized silicon substrate of a CNT sample to heat a 2×2 mm2 wick area. As a heater, it provides a direct heating effect without a thermal interface and is capable of high-temperature operation over 800°C. As a thermometer, reliable temperature measurement is achieved by calibrating the resistance variation versus temperature after the annealing process is applied. The thermally oxidized layer on the silicon substrate is around 1-μm-thick and pinhole-free, which ensures the platinum thermometer/heater from the severe CNT growth environments without any electrical leakage. For high-heat-flux cooling, the CNT biwick structure is composed of 250 μm tall and 100 μm wide stripelike CNT clusters with 50 μm stripe-spacers. Using 1×1 cm2 CNT biwick samples, experiments are completed in both open and saturated environments. Experimental results demonstrate 600 W/cm2 heat transfer capacity and good thermal and mass transport characteristics in the nanolevel porous media.

Thermal Management for Purification of Aligned Arrays of Single-Walled Carbon Nanotubes Based on Thermocapillary Flow by Pulsed Heating

Laser-induced Nanoscale Thermocapillary Flow for Purification of Aligned Arrays of Single-Walled Carbon Nanotubes.

Modeling of thermocapillary flow to purify single-walled carbon nanotubes

Investigation on self-heating effect in carbon nanotube field-effect transistors

Electrothermal Characterization of Single-Walled Carbon Nanotube (SWCNT) Interconnect Arrays

Thermal Analysis For Laser Selective Removal Of Metallic Single-Walled Carbon Nanotubes

Quantitative Thermal Imaging of Single-Walled Carbon Nanotube Devices by Scanning Joule Expansion Microscopy.

Electrothermal Characterization of Carbon Nanotube Field Effect Transistors (Cntfets)

Using Nanoscale Thermocapillary Flows to Create Arrays of Purely Semiconducting Single-Walled Carbon Nanotubes

Microwave Purification of Large-Area Horizontally Aligned Arrays of Single-Walled Carbon Nanotubes

Fundamental Effects in Nanoscale Thermocapillary Flow

Nanoscale Heat Transport of Vertically Aligned Carbon Nanotube Bundles for Thermal Management Applications

Thermomechanical Modeling of Scanning Joule Expansion Microscopy Imaging of Single-Walled Carbon Nanotube Devices

Design and Test of Carbon Nanotube Biwick Structure for High-Heat-Flux Phase Change Heat Transfer

Modelling Heat Transfer of Carbon Nanotubes

Advances of CNT-based Systems in Thermal Management

Regulatable Thermal Conductivity and Excellent Mass Transport of Water-Filled Carbon Nanotube As Capillary Wicks

Sorting out Semiconducting Single-Walled Carbon Nanotube Arrays by Preferential Destruction of Metallic Tubes Using Xenon-Lamp Irradiation

The Inherent Thermal Effect of Substrates on the Growth of Ultralong Carbon Nanotubes

Analytical Thermal Modeling of Nanowire Structures Including Self-Heating Effects

Fabrication of High Thermal Conductivity Carbon Nanotube Arrays by Self Assembled Fe 3 O 4 Particles