Abstract:As process technologies advance into deep sub-micrometer and nanometer scale, the charged device model (CDM) is now considered an important stress model for defining electrostatic discharge (ESD) reliability of integrated circuits. Thus the turn-on time of the ESD elements used in the protection circuit becomes important. At this time, there is no good method to evaluate the CDM ESD device turn-on speed. Equipment like VF-TLP and CC-TLP are too complicated and not precise for this purpose. A new method to evaluate the ESD device turn-on speed is presented in this paper. Based on this novel approach, some CDM ESD devices are analyzed based on the transmission line pulsing (TLP) tester. The designed devices include diodes, grounded-gate NMOS, SCRpsilas (silicon controlled rectifier), and Modified-Lateral SCRpsilas (MLSCR). The rising time of the pulse is set at 200 psec to accurately simulate real CDM pulses. The time-dependent voltage and current data are extracted and calculated from each pulse in the Time Domain Reflection (TDR) TLP tester. Two new ESD turn-on conditions are proposed and defined based on the transient currents in order to compare the relative speed of different ESD devices. The results show that the normalized turn-on time of different devices with various sizes and finger numbers do not correlate well with that obtained under the normal DC conditions, and the same device shows different turn-on characteristics under different pulses. These results enable devices to be designed for improved CDM ESD protection levels, and the present method can be used for ESD design for future nanometer technologies.

Double Snapback Phenomena in Transient Power-Rail Esd Clamp Circuits for Latch-Up Free Concerns

Silicon-Controlled Rectifier Stacking Structure for High-Voltage ESD Protection Applications

Electro-Thermo-Mechanical Investigation On Multi-Level Interconnects In The Presence Of An Esd Pulse

Power-rail ESD Clamp Circuit with Hybrid-Detection Enhanced Triggering in a 65-Nm, 1.2-V CMOS Process.

Power-Rail Esd Clamp Circuit With Parasitic-Bjt And Channel Parallel Shunt Paths To Achieve Enhanced Robustness

Design of a Novel Static-Triggered Power-Rail ESD Clamp Circuit in a 65-Nm CMOS Process

A Prolonged Discharge Time ESD Power-Rail Clamp Circuit Structure with Strong Ability to Prevent False Triggering

Effects of process variation on turn-on voltages of a multi-finger gate-coupled NMOS ESD protection device

A Double Snapback SCR ESD Protection Scheme for 28 Nm CMOS Process.

An Improved Ggnmos Triggered Scr for High Holding Voltage Esd Protection Applications

Novel Insights into the Power-off and Power-on Transient Performance of Power-Rail ESD Clamp Circuit

Area-saved and Low-Leakage Design of Power-Rail Clamp Circuit

Investigation of Turn-on Speeds of Electrostatic Discharge Protection Devices Using Transmission-Line Pulsing Technique

Area-efficient Transient Power-Rail Electrostatic Discharge Clamp Circuit with Mis-Triggering Immunity in a 65-Nm CMOS Process

Design of Power-Rail ESD Clamp Circuit with Separate Detection Component and Delay Component Against Mis-Triggering

Trigger voltage walk-in effect of ESD protection device in HVCMOS

New Power Clamp Circuit for Concurrent ESD and Surge Protections

Investigation of the Trigger Voltage Walk-In Effect in Ldmos for High- Voltage Esd Protection

A False Trigger-Strengthened and Area-Saving Power-Rail Clamp Circuit with High ESD Performance

Modeling Study of Power-On and Power-Off System-Level Electrostatic Discharge Protection

Area-Efficient Power-Rail ESD Clamp Circuit with False-Trigger Immunity in 28nm CMOS Process