Abstract:Dislocation loops in quenched aluminum alloys are usually seen deviating from their nominal habit planes, while the orientation distribution and deviation mechanism are far from understanding. Based on the method of tomographic crystallography of dislocations and correlative in-situ heating experiments in transmission electron microscopy (TEM), we revisit the three-dimensional (3D) characteristics and deviation behaviors of dislocation loops in a quenched Al-Cu alloy with an aim to fully unravel the relationship between dislocation crystallography and deviation behaviors. The results show that all the dislocation loops exhibit approximately circular shapes and have a/2 < 110>-type Burgers vectors, with loop orientations deviating from their pure edge orientation {110} of 0°-17.8° and distributing mainly close to the [101]-[001] and [101]-[111] edges of the standard stereographic triangle. Three types of deviation behaviors of dislocation loops are then defined, which are characterized by loop rotation around 〈100〉, 〈110〉 and irregular axes, respectively. Theoretical calculations of strain energy variation with increasing deviation angle indicate that the relatively low energy barrier may account for a high frequency of loop deviation in the low angle range. Detailed in-situ TEM heating experiments and correlative tomographic crystallography analyses strongly demonstrate the specific roles of dislocation gliding and climbing at elevated temperatures in the shrinkage, polygonization and deviation processes of dislocation loops, and the competitive and cooperative motion of dislocation segments close to slip planes {111} are the fundamental reasons for the formation of three types of deviated dislocation loops.

Experimental Characterization of Dislocations in Deformation Induced Planar Boundaries of Rolled Aluminium

Dislocation content of geometrically necessary boundaries aligned with slip planes in rolled aluminium

Dislocations, Boundaries and Slip Systems in Cube Grains of Rolled Aluminium

Inclination-governed Deformation of Dislocation-Type Grain Boundaries

Internal structures of deformation induced planar dislocation boundaries

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Rolled Aluminium

Arrangement and Decomposition of Grain Boundary Dislocations: Two-Mode Phase-Field Crystal Simulation

Grain Orientation Dependence of Extended Planar Dislocation Boundaries in Cold-Rolled Polycrystalline Aluminium

Orientation distribution and deviation behaviors of dislocation loops in a quenched Al-Cu alloy

First-Principles Study of Physical Properties of (110) Symmetric Small-Angle Tilting Grain Boundary with Full Dislocation in Aluminum

Dislocation Electron Tomography of Boundaries in Deformed Aluminium

Dislocations Observed by Transmission Electron-Microscopy in the Quasi-Crystalline Phase T2 of Al-Li-Cu after Deformation

Dislocation Boundaries and Slip Systems in Uniaxially Deformed Crystals

Observing Dislocations Transported by Twin Boundaries in Al Thin Film: Unusual Pathways for Dislocation-Twin Boundary Interactions

Resolving localized geometrically necessary dislocation densities in Al-Mg polycrystal via in situ EBSD

Dislocation Boundary Structure from Low to Medium Strain of Cold Rolling AA3104 Aluminum Alloy

Electron Tomography of Dislocations in an Al-Cu-Mg Alloy

Sliding behaviour and dislocation structures in aluminium grain boundaries

Atomistic Study of Fundamental Character and Motion of Dislocations in Intermetallic Al2Cu

Interactions Between Non-Screw Lattice Dislocations and Coherent Twin Boundaries in Face-Centered Cubic Metals

The Interaction Mechanism of Screw Dislocations with Coherent Twin Boundaries in Different Face-Centred Cubic Metals