Abstract:We report a type of multimode fiber interferometers (MMI) formed in photonic crystal fiber (PCF). To excite the cladding modes from the fundamental core mode of a PCF, a coupling point is formed. To form the coupling point, we used the method that is blowing compressed gas into the air-holes and discharging at one point, and the air-holes in this point will expand due to gas expansion in the discharge process. By placing two coupling points in series, a very simple all-fiber MMI can be implemented. The detailed fabrication process is that the one end of the PCF is tightly sealed by a short section of single mode fiber (SMF) spliced to the PCF. The other end of the PCF is sealed into a gas chamber and the opened air holes are pressurized. The PCF is then heated locally by the fusion splicer and the holes with higher gas pressure will expand locally where two bubbles formed. We tested the RI responses of fabricated sensors at room temperature by immersing the sensor into solutions with different NaCl concentration. Experimental results show that as refractive-index (RI) increases, the resonance wavelength of the MMI moves toward longer wavelengths. The sensitivity coefficients are estimated by the linear fitting line, which is 46nm/RIU, 154mn/RIU with the interferometer lengths (IL) of 3mm and 6mm. The interferometer with larger IL has higher RI sensitivity. The temperature cross-sensitivity of the sensor is also tested. The temperature sensitivity can be as low as -16.0pm/degrees C.

Intensity Modulation Photonic Crystal Fiber Based Refractometer in the Visible Wavelength Range

High Sensitivity Evanescent Field Refractometer Based on Modal Interference in Micro-Capillary Wall

A Novel Photonic Crystal Fiber Mach–Zehnder Interferometer for Enhancing Refractive Index Measurement Sensitivity

High-sensitivity refractive index sensors based on fused tapered photonic crystal fiber

A High Sensitivity Refractive Index Sensor Based on Photonic Crystal Fibre Mach–Zehnder Interferometer

Novel Intensity-demodulated Fiber-optic Refractive Index Sensor Based on Splicing Point Tapered Fiber

Refractive index measurement using photonic crystal fiber-based Fabry-Perot interferometer.

Photonic crystal fiber refractive-index sensor based on multimode interferometry

A Reflective Fiber-Optic Refractive Index Sensor Based on Multimode Interference in A Coreless Silica Fiber

Highly sensitive refractive index sensing based on a novel Mach-Zehnder interferometer with TCF-PCF composite structure

A Sensitivity-Enhanced Refractive Index Sensor Using A Single-Mode Thin-Core Fiber Incorporating an Abrupt Taper

Photonic Crystal Fiber-Based Modal Interferometer for Refractive Index Sensing

Intensity Modulated Refractive Index Sensor Based on Optical Fiber Michelson Interferometer

A High‐sensitivity Refractometer Based on Etched Thin‐core Fiber Modal Interferometer

Ultra-Sensitive Refractive Index Sensor with Slightly Tapered Photonic Crystal Fiber

High-sensitive measurements of refractive-index and magnetic-field based on liquid-infiltrated photonic crystal fiber with an elliptically-shaped core

Slight-Offset Tapered Multimode Fiber with High Sensitivity for Low Refractive Index Range

Tunable Mode Coupler in the Microfluidic Channel for the Fiber Optics Refractive Index Sensor

Intensity-Interrogated Refractive Index Sensor Based on Exposed-Core Multicore Fiber Mach-Zehnder Interferometer

Refractive Index Measurement Based on Thin-Core Fiber In-Line Mach-Zehnder Interferometer and Differential Intensity Demodulation

Thin-Core Fiber Sandwiched Photonic Crystal Fiber Modal Interferometer for Temperature and Refractive Index Sensing